Garmin Delta Sport Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Средство для ухода за домашними животными Garmin Delta Sport. Garmin Delta Sport 12 страниц. Delta series
Также для Garmin Delta Sport: Информация о продукте (12 страниц)
Печатать страницу
TIP: For bark correction, the device contact points should be
positioned near the dog's vocal cords. This location varies
based on the breed of dog. If the device does not seem to
detect the dog's barks, you should move the device closer to
or farther from the dog's body to find the ideal location.
3
Tighten the strap so that it is very snug around the dog's
neck, and fasten the buckle.
NOTE: The collar should fit tightly and should not be able to
rotate or slide on the dog's neck. The dog must be able to
swallow food and water normally. You should observe your
dog's behavior to verify that the collar is not too tight.
Training Modes
The Delta system provides several training modes, which assign different combinations of momentary stimulation, continuous
stimulation, tone, and vibration to the training keys
key functions, from top to bottom. Training keys that activate a stimulation are designated as high or low.
Mode
Top Key
TVM
Tone
VCM
Vibration
TCM
Tone
CMM (Delta Sport only) Continuous (high) Momentary (high) Momentary (low) Advanced training, popular for bird-dog training
MCC (Delta Sport only) Momentary (high) Continuous (high) Continuous (low) Advanced training, popular for obedience training
Selecting a Training Mode
You can select a different training mode for each dog collar
device.
1
Select a dog collar device
2
Select to toggle through the available training modes.
Choosing the Correct Intensity Level
1
Set the intensity to the lowest level
2
Press a training key.
3
Observe the dog for a reaction, such as a head shake, neck
movement, or just a change in expression.
Sometimes dogs will vocalize due to the surprise of the
electrical stimulation. If the dog vocalizes more than once,
the intensity level is too high for beginning training.
4
If there is no reaction, increase the intensity level by one
level until the dog has a slight but recognizable reaction to
the stimulation.
The intensity level that causes a slight but recognizable reaction
is your dog's baseline level for beginning collar training. You do
not need to, and should not, apply this intensity selection test
again.
After you begin training, the dog's performance guides your
intensity selection. As the dog advances in training, you may
need to change the level depending upon the training situation.
Dog Training
(page
Middle Key
Vibration
Continuous (high) Momentary (high) All-around training
Continuous (high) Momentary (high) All-around training
(page
2).
(page
3).
4
Wiggle the device to work the contact points through the
dog's coat.
NOTE: The contact points must have contact with the dog's
skin to be effective.
5
If the strap is too long, cut off the excess, leaving at least
3 in. (8 cm) to spare.
TIP: You can mark the hole used to fasten the buckle for
future reference.
Training Intensities and Methods
The Delta system uses momentary (M) and continuous (C)
stimulation. Momentary stimulation applies a brief stimulation
when you press the training key, regardless of how long the key
is depressed. Continuous stimulation applies stimulation to the
dog the entire time you press the training key, for a maximum of
8 seconds. Your stimulations should typically be much shorter
than 8 seconds.
The Delta system provides 18 stimulation intensity levels, which
increase sequentially from 1 to 18.
You can also train using a tone (T) or vibration (V). When a key
is set for tone, the key press activates an audible tone instead
of stimulation. A tone can be used as either a positive or
negative training cue, depending on your training program.
When a key is set for vibration, the key press activates a short
vibration instead of stimulation. The effectiveness vibration may
vary based on the dog's temperament and experience.
3). The three vertical letters on the LCD display correspond to the training
Bottom Key
Description
Momentary (low) Beginning trainer, sensitive dog, or minor corrections
Changing the Intensity Level
You can select a different intensity level for each dog collar
device.
1
Select a dog collar device
2
Select
or
The numerical intensity level appears on the LCD display.
Basic Training Commands
You should begin training your dog with a few basic commands
without using the Delta training system to correct the dog. You
should train the three basic commands in the following order:
"heel," "sit," and "here."
During initial training, you should put the dog collar device on
the dog, but the device should be turned off. This allows the dog
to get used to the device before you start using it to correct the
dog. This also helps to prevent "collar-wise" behavior
(page
4).
Initially, you should keep the training sessions short and only
train one command during a session. This way, the dog is less
likely to become confused and training should progress more
quickly. Pay close attention while training the dog, so you can
begin to learn when to go faster or slower, and when to take a
break.
With plenty of repetition, consistency, patience, and a lot of
praise, the dog should begin to obey these commands after
(page
2).
to increase or decrease the intensity level.
3