Garmin Pro 550 Инструкции по замене батареи - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по замене батареи для Средство для ухода за домашними животными Garmin Pro 550. Garmin Pro 550 10 страниц. Pro series remote trainer collar
Также для Garmin Pro 550: Руководство пользователя (8 страниц)
Печатать страницу
Pro Series Dog Collar Device Battery
Replacement Instructions
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use a sharp object to remove batteries.
Contact your local waste disposal department to properly
recycle the batteries.
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
For more information, go to
.html.
Pro Series Dog Collar Device Components
Security screws
Top plate
Battery plate screws
Battery plate
Battery
Gasket
Front enclosure
Replacing the Pro 70 and Pro 550 Dog Collar
Device Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need a small Phillips
screwdriver and the security screwdriver included with the
battery replacement kit.
1
Remove the six screws from the top plate, and remove the
top plate.
2
Remove the two screws from the battery plate, and remove
the battery plate.
3
Grip the battery connector wires close to the connector, and
pull the connector parallel to the circuit board to disconnect
the battery connector from the device.
2
WARNING
CAUTION
www.garmin.com/support/warranty
4
Remove the battery.
The battery fits tightly. It may be necessary to pry the battery
out of the back plate using a non-sharp, non-metal object.
5
Install the new battery into the front enclosure with the label
side of the battery facing up, and the leading edge of the
battery placed under the charging contact ledge of the
device.
6
Replace the battery plate, and replace and tighten the two
screws.
7
Verify the gasket is not damaged and is completely seated in
the groove.
8
With the new battery, connect the battery connector to the
device.
When properly installed, the connector plug snaps into the
port.
9
Replace the front plate, and replace and tighten the six
screws to secure the front plate.
10
Verify the gasket is not sticking out of the device.
Replacing the Pro Trashbreaker Dog Collar
Device Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need a small Phillips
screwdriver and the security screwdriver included with the
battery replacement kit.
1
Remove the three screws
antenna
.
2
Pry off the cover.
3
Remove the screw securing the VHF antenna to the back
plate.
4
Remove the six screws from the top plate, and remove the
top plate.
5
Remove the two screws from the battery plate, and remove
the battery plate.
from the cover
over the VHF