Brother DCP-6690CW Руководство по быстрой настройке - Страница 28

Просмотреть онлайн или скачать pdf Руководство по быстрой настройке для Принтер "все в одном Brother DCP-6690CW. Brother DCP-6690CW 43 страницы.

Печатать страницу

For Wireless Network Users

Configure the wireless

settings using the

automatic wireless (one-

push) method

Confirm your wireless router or access point

has the SecureEasySetup™, Wi-Fi Protected

Setup™ or AOSS™ symbol as shown below.

Place the Brother machine within range of a

SecureEasySetup™, Wi-Fi Protected Setup™

or AOSS™ access point/router. The range may

differ depending on your environment. Refer to

the instructions provided with your access

point/router.

Push the SecureEasySetup™, Wi-Fi Protected

Setup™ or AOSS™ button on your wireless

router or access point.

See the user's guide for your wireless router or

access point for instructions.

On your machine, press MENU.

Press a or b to display Network and press

Network.

Press WLAN.

Press SES/WPS/AOSS.

When Switch Network interface to

wireless? is displayed, press Yes to accept.

This will start the wireless setup wizard.

To cancel, press No.

This feature will automatically detect which

mode (SecureEasySetup™, Wi-Fi Protected

Setup™ or AOSS™) your access point uses to

configure your machine.

Note

If your wireless access point supports Wi-Fi

Protected Setup™ (PIN Method) and you want to

configure your machine using the PIN (Personal

Identification Number) Method, see Using the PIN

Method of Wi-Fi Protected Setup™ in the Network

User's Guide on the CD-ROM.

If the LCD shows Connected, the machine

has successfully connected to your router or

access point. You can now use your machine

in a wireless network.

If the LCD shows Setting WLAN,

Connecting SES (Connecting WPS or

Connecting AOSS), then

Connection Failed, the machine has not

successfully connected to your router or

access point. Try starting from c again. If the

same message is indicated again, reset the

machine back to the default factory settings

and try again. For resetting, see Restore the

network settings to factory default on page 41.

If the LCD shows Setting WLAN, then

Connection Failed or Incorrect Mode,

a session overlap or connection failure was

detected. (see the table below), the machine

has detected 2 or more routers or access

points on your network that have the

SecureEasySetup™, Wi-Fi Protected Setup™

mode or AOSS™ mode enabled. Make sure

that only one router or access point has the

SecureEasySetup™, Wi-Fi Protected Setup™

mode or AOSS™ mode enabled and try

starting from c again.

LCD messages when using the

SES/WPS/AOSS control panel menu

Searching or accessing the

Setting WLAN

access point and downloading

settings from the access point.

Connecting to the access

Connecting

point.

SES/WPS/AOSS

Connection failed. If this is

Connection

shown after the LCD shows

Failed

Connecting

SES/WPS/AOSS, a session

overlap was detected.

A session overlap was

Incorrect

detected.

Mode

The machine has successfully

Connected

connected.

Note

If you encounter a problem during setup,

temporarily place your machine closer to the

wireless access point, and go back to c.

Wireless setup is now complete.