AEG OKO FAVORIT 676 Руководство по эксплуатации - Страница 20
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Посудомоечная машина AEG OKO FAVORIT 676. AEG OKO FAVORIT 676 24 страницы. Dishwasher
Также для AEG OKO FAVORIT 676: Руководство по эксплуатации (25 страниц), Руководство по эксплуатации (24 страниц)
Печатать страницу
Information for the installer
Installation
The appliance must stand level and on a firm
floor. The floor should be clean and free from
floor polish and grease. The appliance has
adjustable feet. If necessary adjust feet.
Should a freestanding machine be built under
a worktop in a built-in kitchen, the table top of
the machine can be removed. In this case you
need to protect the underside of your kitchen
furniture worktop at the front with an aluminium
foil strip which is available as an optional extra
from AEG Spare Parts Department. You will
find details how to secure the aluminium foil
strip on the-back of the strip. This is the only
way your worktop will be protected against
steam being emitted when the dishwasher
door is opened.
Water supply
This dishwasher is equipped with an anti-
flood device to be fitted to the water tap —
AQUA-LOCK (see also page 22). To ensure
the correct operation of this anti-flood device
it is imperative that the double-skin inlet hose
is connected to the water supply in a particu-
lar way.
Please see separate installation instructions
supplied with the machine.
To protect the drinking water supply system
your dishwasher is fitted with an anti-syphon.
A connection to a hot water supply up to a
maximum of 60°C with.a minimum pressure of
{1 bar is possible, although the machine must
not be connected to single outlet instantane-
ous electric or gas heaters.
Please ensure you comply with the drinking
water regulations of your local Water Board.
The high pressure hose with 34" hose
coupling complete with sealing washers is
supplied. We recommend
not to use other
washers which may be of inferior quality. It is
sufficient to tighten the nuts by hand.
The machine may be connected:
a) directly to a tap with 34" BSP thread
termination
b) to a T-junction on your existing tap, or
preferably
To comply with Safety Regulations, the
machine must be installed in such a way that
there is no access to live parts or internal
connections with functional insulation.
Please note
(this applies to free-standing appliances with
worktop only)
Should a dishwasher be installed next to a
gas, solid fuel or electric cooker due to lack of
space, a heat insulating panel (85 x 57.5 cm)
has to be fitted, the side facing the cooker has
to be lined with aluminium foil.
c) to a completely seperate water supply in
order to avoid interference with the kitchen
water supply during operation of the
machine.
Minimum water pressure: approx. 1 bar pres-
sure above atmospheric pressure (1 atu =
approx. 1 kp/cm? = approx. 10 N/cm2. For less
than one bar of pressure above atmospheric
pressure, consult the AEG Technical Depart-
ment. Maximum
permissible water pressure:
approx. 10 bars. For over 10 bars excess
pressure, connect a pressure relief valve
(obtainable through your installer).
If a longer water supply hose is needed it
should be a single run of high pressure hose
available in one length from AEG Spare Parts
Department. Never add extensions to hoses.
Turn off the water tap if the machine is not in
use. A rigid copper pipe connection (diameter
8-10 mm) can be used as extensions for
machines fitted with AQUA-LOCK.
20