a-gear OPM HOPM-PON-S Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Измерительные приборы a-gear OPM HOPM-PON-S. a-gear OPM HOPM-PON-S 20 страниц. Pon optical power meter
Печатать страницуA-GEAR World Wide Manufacturing
Key Fu n c t io n
4 .2 .
Key
O pe r at io n in s tr u c t io n :
4 .3 .
4. 3 .1 .
Powe r O N
Press
for about one second to make the until power on, Enter into the PON
power meter function, the unit displays as shown in below figure:
As shown in above figure, the LCD will display simultaneously three wavelengths of
1310nm upstream measurement and 1490nm,1550nm downstream measurements.
When optical signal is present under test, the optical channel will display power levels
in dBm, when optical signal is not available, then the optical channel will display
«LOW». «
» indicates 10 minutes auto-off function is activated. The unit will turn
itself off after 10 minutes of idle time. Press
4. 3 .2 .
Powe r O F F
Press
for about one second, to turn off the unit.
Turns unit on (Press for one second); Controls 10 minutes Auto power off
function (press for half second); Turns unit off (Press for one second)
PON/CW Power meter module Option
Function Option, value adjustment
Confirmation the function selection and saving the data
Shit the CW wavelength to the modulation (Hz) wavelength
Fu nc ti o n
Function cancel
to close 10 minutes auto-off.
OPM HOPM-PON-S
datasheet
a-gear.net
Раge 7 of 20