AEG 66300 K-IN Руководство по установке и эксплуатации - Страница 31
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Варочная панель AEG 66300 K-IN. AEG 66300 K-IN 40 страниц. Ceramic glass hob
Также для AEG 66300 K-IN: Руководство по установке и эксплуатации (31 страниц)
Печатать страницу
Built-in installation
• In order to facilitate access if servicing is required, there must be a
space the size of the cut-out section in the worktop and 150mm high
under the hob. Anything installed in this area, e.g. anti-shock protec-
tion, must be easily removable.
• If installing flush with the work surface, use the sealing tape with di-
mensions 10x3mm.
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing tape supplied onto the up-
per surface of the rabbet along the edges of the cut-out section.
– Cut the sealing tape into four pieces relating to the length of the
edges of the rabbet.
– For the four corners of the rabbet the ends of the sealing tapes
must be cut into mitres. Do not stick the ends over one another.
– Stick the sealing tape flush into the corner of the rabbet, so that no
silicon compound can get under the glass ceramic when grouting.
– Don't stretch the tapes when sticking them on.
Installation proud of the work surface
• If installing proud of the work surface, use the sealing tape with di-
mensions 6x2mm.
• Clean the worktop around the cut-out area.
• Stick the single-sided adhesive sealing tape provided on the under-
side of the hob around the outside edge ensuring that it is not
stretched. The two ends of the tape should join in the middle of one
side. After trimming the tape (allow it to overlap by 2-3 mm), press
the two ends together.
31