Fujitsu ESPRIMO V6515 Простое руководство - Страница 27

Просмотреть онлайн или скачать pdf Простое руководство для Ноутбук Fujitsu ESPRIMO V6515. Fujitsu ESPRIMO V6515 34 страницы.

Печатать страницу

Removing and installing memory modules

Mainmemory
System expansion
Memoryupgrade
Memoryexpansion
Your notebook supports dual-channel DDR2 technology.
The dual-channel DDR2 technology can only be used with two identical memory
modules. When two different memory modules are installed, only "single-channel"
mode is supported. This reduces the performance of your notebook.
With a memory configuration of 4 GBytes, the visible and usable main memory
may be reduced to 3 GBytes (depending on notebook configuration).
If you are asked by the Hotline/Help Desk to remove and install the memory
modules yourself, proceed as follows:
Pay attention to the relevant safety notes provided in the "Important notes" chapter.
The notebook must be switched off when installing/removing the memory
modules, it must not be in Suspend mode.
Only use approved memory expansion modules in your notebook (see
Section
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory expansion compartment.
Individual components (e.g. the processor heat sink) can become very hot
during operation. Therefore, we recommend that you wait one hour after
switching off the notebook before removing or installing the memory modules.
Otherwise, there is a risk of suffering burns!
As some non-ESD safe components are exposed, please observe the section
on installing and removing boards and components", Page
► Switch your notebook off and unplug the mains adapter from the mains outlet.
► Close the LCD screen so that it locks into place.
► Disconnect all cables connected to the notebook.
► Turn your notebook over and place it on a stable, flat and clean surface. If necessary, lay
an anti-slip cloth on this surface to prevent the notebook from being scratched.
► Remove the battery (see
A26391-K245-Z220-1-7619, edition 1
Removing and installing components during servicing
"Technical specification", Page
"Removing the battery", Page
23).
16.
12).
"Notes
19