Fujitsu LifeBook C-6591 Руководство по программному обеспечению - Страница 5
Просмотреть онлайн или скачать pdf Руководство по программному обеспечению для Ноутбук Fujitsu LifeBook C-6591. Fujitsu LifeBook C-6591 39 страниц. Bios setup utility
Также для Fujitsu LifeBook C-6591: Руководство по биосфере (40 страниц)
Печатать страницу
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed.
Main
Primary Master [TOSHIBA MK6014MAP-(PM)]*
Type:
Maximum Capacity:
Multi-Sector Transfers:
LBA Mode Control:
PIO Transfer Mode:
DMA Transfer Mode:
F1
Help
ESC
Exit
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field
Options
Type:
Auto
None
CD-ROM
Hard Disk
Cylinders:
A number
between 0
and 65,535
Heads:
A number
between 1
and 16
Sectors:
A number
between 0
and 63
PhoenixBIOS Setup Utility
[Auto]
12073MB
[16 Sectors]
[Enabled]
[Fast PIO 4]
[Ultra DMA 2]
Select Item
-/Space
Select Menu
Enter
Figure 2 Primary Master Submenu
Default
[Auto]
–—
–—
–—
M a i n M e n u
* Actual hard drive label shown may vary. Depending on
the drive type, information such as cylinders, heads and
sectors may also be displayed.
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Change Values
F9
Select
Sub-Menu
F10
Description
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and
Sectors for the drive.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
This item appears only when Hard Disk is selected. When Hard Disk
is selected, you can change the value. This field is changed by
incrementing (pressing the [Spacebar]) or by typing in the number.
Setup Defaults
Save and Exit
5