AEG L 60260 TL 1 Руководство пользователя - Страница 22
Просмотреть онлайн или скачать pdf Руководство пользователя для Стиральная машина AEG L 60260 TL 1. AEG L 60260 TL 1 32 страницы.
Также для AEG L 60260 TL 1: Руководство пользователя (28 страниц)
Печатать страницу
22 www.aeg.com
Problem
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
service centre.
TECHNICAL INFORMATION
Dimensions
Electrical connection:
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible cause
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
Width / Height / Depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
Possible solution
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
1200 rpm (L60260TL)
1000 rpm (L60060TL)
400 / 850 / 600 mm
230 V
2200 W
10 A
50 Hz
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
6 kg