Brother Stampcreator PRO SC2000USB Краткая справка - Страница 24
Просмотреть онлайн или скачать pdf Краткая справка для Изготовитель этикеток Brother Stampcreator PRO SC2000USB. Brother Stampcreator PRO SC2000USB 36 страниц.
Печатать страницу
After you have designed a stamp layout using the P-touch Editor software or Stampcreator Express software, you can
engrave it into a stamp.
Installing the ink ribbon cassette
a Press down on the ink ribbon compartment cover button to open the
cover.
☞ Open and close the ink ribbon compartment cover by pressing
only on the positions specified.
b If the ink ribbon in the cassette is loose, turn it over and use your finger
to wind the toothed wheel on the large knob on the right side until
there is no slack in the ribbon.
c Insert the knobs on the left end of the cassette into the slots on the left
side of the compartment, then push down on the right end of the
cassette so that the knobs on the right side slide into the slots on the
right side of the compartment.
d Slowly close the ink ribbon compartment cover so that it locks into
place.
☞ Be careful not to pinch your fingers with the compartment cover while closing it.
Loading draft sheets and installing the draft tray
a Slide out the inner tray.
b Lift up the draft tray lid.
c Place the draft sheets (with the words "DRAFT SHEET" facing up) into
the draft tray so that the corners of the sheets fit under the tabs in the
front corners of the tray.
☞ No more than 50 draft sheets should be loaded into the draft tray.
Be sure that there is no dust, fingerprints, etc. on the draft sheets.
Do not use a draft sheet that has been folded.
Be sure that a cleaning sheet is not accidentally inserted together
with the draft sheets.
d Close the draft tray lid.
e Slide the inner tray back into the outer case.
Using the SC-2000USB
Ink ribbon
cassette
Slots
Ink ribbon compartment
c
b
a
21