Brother Fax Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Факсимильный аппарат Brother Fax. Brother Fax 44 страницы. Brother internet fax user's guide
Также для Brother Fax: Руководство по эксплуатации (15 страниц)

Печатать страницу

RARP mode

Brother Print / Fax server IP address can be configured using the

Reverse ARP (RARP) facility on your host computer. This is done by

editing the /etc/ethers file (if this file does not exist, you can create it)

with an entry similar to the following:

00:80:77:31:01:07

Where the first entry is the Ethernet address of the Print / Fax server

and the second entry is the name of the Print / Fax server (the name

must be the same as the one you put in the /etc/hosts file).

If the rarp daemon is not already running, start it (depending on the

system the command can be rarpd, rarpd -a, in.rarpd -a or something

else; type man rarpd or refer to your system documentation for

additional information). To verify that the rarp daemon is running on

a Berkeley UNIX-based system, type the following command:

ps -ax | grep -v grep | grep rarpd

For AT&T UNIX-based systems, type:

ps -ef | grep -v grep | grep rarpd

The Brother Print / Fax server will get the IP address from the rarp

daemon when it is powered on.

BOOTP mode

BOOTP is an alternative to rarp that has the advantage of allowing

configuration of the subnet mask and gateway. In order to use

BOOTP to configure the IP address make sure that BOOTP is

installed and running on your host computer (it should appear in the

/etc/services file on your host as a real service; type man bootpd or

refer to your system documentation for information). BOOTP is

usually started up via the /etc/inetd.conf file, so you may need to

enable it by removing the "#" in front of the bootp entry in that file. For

example, a typical bootp entry in the /etc/inetd.conf file would be:

#bootp dgram udp wait /usr/etc/bootpd bootpd -i

Depending on the system, this entry might be called "bootps"

instead of "bootp".

1 - 3 CONTROL PANEL SETUP

BRN_310107