Fujitsu ETERNUS DX Disk Руководство по конфигурации - Страница 23

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Сервер Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 страниц. Server connection, fcoe for linux driver settings for converged network adapter cards
Также для Fujitsu ETERNUS DX Disk: Руководство пользователя (35 страниц), Руководство пользователя (42 страниц), Руководство по конфигурации (28 страниц), Руководство по конфигурации (44 страниц), Руководство по конфигурации (28 страниц), Руководство по конфигурации (29 страниц), Руководство по конфигурации (25 страниц), Руководство по конфигурации (32 страниц), Руководство по конфигурации (31 страниц), Руководство по конфигурации (43 страниц), Руководство по конфигурации (21 страниц), Руководство по конфигурации (24 страниц)

Печатать страницу
Fujitsu ETERNUS DX Disk Руководство по конфигурации
Chapter 2
Setup Procedure for QLogic Converged Network Adapter Cards
2.2

Setting Up the Converged Network Adapter Cards

2.2
Setting Up the Converged Network Adapter Cards
This section describes how to set up the server with the QLogic Converged Network Adapter cards described
in the "Server Support Matrix".
Depending on the Converged Network Adapter card used, the actual on-screen Converged Network Adapt-
er card information may differ from that in the screenshots shown in this manual.
2.2.1
Setting Up the Converged Network Adapter Cards
Install the Converged Network Adapter card to the server, and acquire the physical address and World Wide
Name (WWN) for the Converged Network Adapter card.
The physical address and WWN of a Converged Network Adapter card are required information in the fol-
•
lowing cases: when an error has occurred in the system, when using the ETERNUS DX storage systems (se-
curity function, host affinity function, etc.) to restrict server access, or when connecting the ETERNUS DX
storage systems and the server using a Fibre Channel switch and a CEE/FCoE switch.
Acquire the physical address and WWN when installing the Converged Network Adapter card, because they
•
cannot be determined from BIOS and OS. Physical address and WWN must be assigned to "WWN instance
management table for the server".
The workflow is shown below.
(1) Install the Converged Network Adapter card
(2) Turn on the server
(3) Acquire the physical address and WWN for the Converged Network Adapter card
(4) Add a record for the server in the WWN instance management table for the server
(5) Set the Converged Network Adapter card BIOS
When installing two or more Converged Network Adapter cards in the server, first turn off the server, then
repeat Steps (1) through (5) above for each Converged Network Adapter card to be installed.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
23
Copyright 2015 FUJITSU LIMITED
®
ESX
P3AM-4772-11ENZ0