Fujitsu PRIMEPOWER 800 Руководство по аппаратной платформе - Страница 33
Просмотреть онлайн или скачать pdf Руководство по аппаратной платформе для Сервер Fujitsu PRIMEPOWER 800. Fujitsu PRIMEPOWER 800 50 страниц. Operation for solaris 10 operating system
Печатать страницу
Message
Illegal value for
[ParameterName].
fail to FragCount
Multiple fragments in
descriptor area
bind to 802.2 failed
pci_config_setup_failed
soft state alloc failed.
Allocation of descriptor
memory failed
fail to
ddi_dma_bind_handle
Could not allocate DMA
handle
Could not bind descriptor
memory
fjgiallocthings failed !!
Unable to map adapter
registers.
ddi_get_iblock_cookie-E
RROR
Unable to install interrupt
routine.
ddi_create_minor_node
failed
ATTACH failed
OPEN failed: ENOMEM
CLOSE: stream==NULL
fjgi_param_register error
fjgi_board_alloc_mem
failed !!
Error filling TX ring
status block can't alloced !!
status block can't alloced
handle!
status block can't bind
handle!
Cause
-role
master: Communicate as Master.
slave: Communicate as Slave.
Error found in the parameter of
definition file (fjgi.conf).
Abnormalities were found in message
fragmentation.
Abnormalities were found in message
fragmentation.
Using protocol was different.
PCI configuration space couldn't be
obtained.
Driver internal resources cannot be
obtained.
Driver internal resources on DMA
couldn't be allocated.
DMA resources couldn't be allocated.
DMA resources couldn't be allocated.
DMA resources couldn't be allocated.
Mapping of register went wrong.
Interrupt
resources
couldn't
allocated.
Unable to install interrupt routine.
Interrupt
resources
couldn't
allocated.
Creation of a device file went wrong.
Driver resources couldn't be allocated.
Driver resources couldn't be freed.
The
ndd
parameter
couldn't
allocated.
Driver resources couldn't be allocated.
Transmit
resources
couldn't
allocated.
Status information resources couldn't
be allocated.
Status information resources couldn't
be allocated.
Status information resources couldn't
be allocated.
Workaround
Check whether the definition file is
correct.
Please try re-activation of interface. If
this is not a cause, report that to your
authorized dealer.
Installed physical memory may be
insufficient or hardware is failed. If
memory insufficient is not a cause,
report that to your authorized dealer.
Installed physical memory may be
insufficient. If this is not a cause,
report them to your authorized dealer.
be
be
be
be
27