FMW51BC1
External Battery Charger
User's Guide
PenCentra 130 / Stylistic LT
The FMW51BC1 external battery charger allows
you to charge up to two battery packs
simultaneously.
Caution
UL Notice: FMW51BC1 External Battery Charger
PenCentra 130 Users: Use this battery charger with
the CP021031 (FMW51BP1) battery pack only.
Stylistic LT Users: Use this battery charger with the
3-cell battery pack CA54200-0502 (FMW29BP2) or
6-cell battery pack CA54200-0506 (FMW29BP1) only.
Using the Battery Charger
To charge your battery pack(s) in the external
battery charger:
1. Connect an FPSI DC power source such as AC
adapter FMWAC4A, FMWAC4B, FMWAC4C
or auto adapter FMWCB2 to the DC input on
the battery charger. The Power status indicator
on the charger turns on indicating that power
is supplied to the charger.
Battery Slot 2
Battery Slot 1
Stylistic LT and PenCentra 130 are trademarks of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc.
6/99
0
Slide
Connector Pins
2. Insert the battery pack into one of the slots in the
battery charger as shown in the following figure
until the battery pack is firmly seated in the charger.
3. There are two status indicators on the battery
charger, one for each slot. The status indicators
change colors to represent different battery
conditions, as noted in Table 1.
Table 1: Status Indicator States
Indicator
Condition
Power
OFF
Green/ON
Battery 1/
OFF
Battery 2
Green/ON
Amber
ON
Blink
2
Red
ON
Blink
1
Blinks at rate of one second on, one second off.
2
If the battery charger indicates a fault condition with the
battery pack, remove the battery pack, disconnect power to
the charger, and contact your local help desk or your reseller
for further assistance.
Rechargeable
Battery Pack
Status
AC Adapter not connected
AC Adapter connected
No battery installed
Charge complete
Charging
1
Standby (Waiting to charge)
Battery pack alarm
1,2
Battery charger alarm
Status
Indicators
Power
1
Battery 1
2
DC Input
Battery 2
58-0664-00A
Печатать страницу