Fujitsu ETERNUS HX Series Установка - Страница 4
Просмотреть онлайн или скачать pdf Установка для Хранение Fujitsu ETERNUS HX Series. Fujitsu ETERNUS HX Series 9 страниц. Installing a cisco nexus 9336c-fx2 switch and pass-through panel in a cabinet, for cisco nexus 9336c-fx2 switches
Также для Fujitsu ETERNUS HX Series: Краткое руководство по эксплуатации (8 страниц)
Печатать страницу
b) Repeat step
2a
with the other front rack-mount bracket on the other side of the switch.
c) Install the rear rack-mount bracket on the switch chassis.
d) Repeat step
2c
with the other rear rack-mount bracket on the other side of the switch.
3. Install the clip nuts in the square hole locations for all four IEA posts.
The two 9336C-FX2 switches will always be mounted in the top 2U of the cabinet RU41 and 42.
4. Install the slider rails in the cabinet.
a) Position the first slider rail at the RU42 mark on the back side of the rear left post, insert screws with
the matching thread type, and then tighten the screws with your fingers.
| Installing a Cisco Nexus 9336C-FX2 switch and pass-through panel in a Fujitsu cabinet |
4