AUTION
The following are important cautions described in this manual
Do not install the scanner on an
unstable work table.
When installing the scanner on a work table,
make sure that the table is flat and level. Place
the scanner so that none of its parts extend
beyond the edge of the table.
Also, it must be strong enough to support the
weights of the scanner and other devices.
Firmly insert the power plug.
Firmly insert the power plug into the Power
outlet as far it can go.
Do not block the ventilation ports.
Do not block the ventilation ports. Blocking the
ventilation ports generates heat inside of the
scanner, which may result in fire or scanner
failure.
Do not place heavy objects or stand
on the top of the scanner.
Do not place heavy objects on the scanner or
stand on its top to perform other work.
Doing so might cause injuries and equipment
failure.
Do not use the scanner immediately
after moving it from a cold place into
a warm room.
Do not use the scanner immediately after
moving it from a cold place into a warm room.
Condensation may occur, which might lead to
scanning errors. Let the scanner dry for one or
two hours before you use it.
Before moving the scanner, discon-
nect the power plug from the Power
outlet.
Do not move the scanner with the power and
interface cables connected as this can damage
the cables, which can later cause fire, electric
shock as well as injuries.
Before moving the scanner, be sure to discon-
nect the power plug from the Power outlet, and
all other interface cables. Make sure that the
floor is free of any obstructions.
Protect the scanner from static
electricity.
Install the scanner away from strong magnetic
fields and other sources of electronic noise.
Also, protect the scanner against any static
electricity, which can cause the scanner to
malfunction.Choose a static-free place to
install the scanner.
Avoid any contact when scanner is in
use.
Avoid getting a sleeve, necktie, or hair caught
up in any scanner mechanism during scanning
since this may cause injuries.
Disconnect the power plug from the
Power outlet when the scanner is not
in use for a long period of time.
When the scanner is not going to be used for a
long period of time, be sure to disconnect the
power plug from the Power outlet.
Do not install the scanner in direct
sunlight.
Do not install the scanner under direct sunlight
or near heating apparatus. Doing so might
cause excessive heat to build up inside the
scanner, which can cause scanner trouble or
even fire. Install the scanner in a well-venti-
lated location.
Do not try to move or lift the scanner
alone.
When transporting the scanner, never carry it
alone. The scanner is heavy.
Before moving the scanner, make
sure the transport lock is locked.
(Flatbed type)
When moving the scanner, be sure to lock the
transport lock and the ADF transport lock in
order to prevent damage to the scanner.
Handle documents carefully.
When handling documents, be careful not to
cut your fingers with them.
Do not make the scanner wet while
carrying it outside.
When carrying the scanner outside while it is
raining or snowing, pay special attention so the
scanner does not get wet.
7
Печатать страницу