Indesit BA 13 Инструкция по установке и использованию - Страница 8

Просмотреть онлайн или скачать pdf Инструкция по установке и использованию для Холодильник Indesit BA 13. Indesit BA 13 18 страниц. Indesit fridge/freezer installation and use

Печатать страницу

Ice trays

This new concept of ice trays is an exclusive Merloni patent.

The fact that they are situated on the inner door of the

freezer compartment ensures greater ergonomics and

cleanliness: the ice no longer comes into contact with the

food placed inside the freezer compartment; furthermore,

the dripping of the water during filling is avoided (a lid to

cover up the hole after filling with water is also provided).

Instructions for use (Fig. 2)

Fill up the tray with water via the special hole up to the level

indicated (MAX WATER LEVEL), taking care not to exceed

it: inserting more water than is necessary will lead to the

formation of ice which could obstruct the exit of the ice

cubes.

If you have used an excessive amount of water, you will

have to wait until the ice has melted, empty out the tray

and re-fill it with water.

Fig. 2

Energy Saving Tips

- Install the appliance correctly

This means that the appliance should be installed away from

heat sources or direct sunlight in a well ventilated room.

- Correct temperature settings

Set the refrigerator or freezer temperature knob to one of

the medium settings. Very low temperatures will not only

consume a great deal of energy but will neither improve or

lengthen the storage life of the food. Excessively low tem-

perature may in fact spoil vegetables, cold meats and cheese.

- Do not overfill your appliance

Remember that proper storage of food requires good air

circulation. Overfilling your appliance will prevent this circu-

lation and overwork the compressor.

- Shut the doors

Open your appliance only when strictly necessary; remem-

ber that every time you open the door most of the cold air

will be lost. The motor will have to run, and consume en-

ergy, to restore the correct temperature.

Once you have filled the ice tray up with water through the

hole indicated, turn it by 90 °. Thanks to the connected

compartments, the water fills up the special shapes, after

which you can cover the hole up with the special cap and

place the ice tray in the inner door of the freezer

compartment.

Once the ice has formed, all you need to do is to knock the

tray against a hard surface so that the ice cubes come away

from their housing and come out of the same hole used to

fill the tray with water. To make it easier for the ice cubes to

come out, wet the outside of the tray.

WARNING: every time you fill up the ice tray with water ,

make sure that the same is completely empty and that there

are no traces of ice left inside it.

The minimum time required for ice to form well is

approximately 8 hours.

- Check the door seals

keep the gaskets clean and soft so that they fit closely against

the door to ensure that no cold air is lost.

- Never store hot foods

A container of hot food in the refrigerator will increase the

temperature significantly; allow food to cool to room tem-

perature before storing.

- Check your appliance for build up of ice

Remember to check the walls of the freezer for frost; when

the frost becomes too thick, defrost the freezer immediately

(See "Maintenance Instructions").