Indesit HOTPOINT LUCE DX1032CX Руководство по эксплуатации - Страница 32
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Печь Indesit HOTPOINT LUCE DX1032CX. Indesit HOTPOINT LUCE DX1032CX 39 страниц. Built-in touch control electronic multifunction 60 cm double oven
Печатать страницу
Indesit
Company
12) Base Element - Top Oven & Main Oven
1.
Remove the right hand side panel, 5 screws).
2.
Top Oven - Loosen the lagging wire, lift up the top cavity lagging and carefully pull out the lagging
between the two cavities.
3.
Main Oven - Loosen the lagging wire and carefully pull up the lower cavity insulation.
4.
Remove the 1 screw from the rear of the chassis which stops the tray from moving out of position.
5.
Disconnect the wires from the element and pull out the top oven base element tray complete with
element.
6.
Remove the element from the base tray.
7.
Replace the element ensuring the element is secured into the location tabs on the base tray.
8.
Push the tray complete with element back into place.
9.
Reassemble in reverse order not forgetting to replace the 1 screw into the rear of the chassis.
13) High Speed Grill - Top Oven
1.
Remove the top oven light lens by turning anti clockwise.
2.
Remove the 2 screws securing the solar plus grill to the rear of the top oven cavity.
3.
Remove the 2 screws securing the grill front to the front support brackets.
4.
Withdraw the element and disconnect the wiring ensuring the wires do not drop back into the rear
panel void.
5.
Reassemble in reverse order using the 2 inner fixing holes to the rear of the cavity.
6.
Ensure the grill front trim is transferred to the new element if required.
14) Main Oven Grill Element
1.
Remove the oven furniture from the oven cavity.
2.
Remove the 2 screws securing the element to the rear of the oven cavity.
3.
Pull the element and its support forward and draw the wires through the cavity, ensuring that the
wires do not drop back into the rear panel void. It may be necessary to remove the rear panel if
the wires fall back.
4.
Transfer the wires to the new element.
5.
Reassemble in reverse order ensuring the grill element is replaced in the correct way with the
support bar uppermost and the side legs of the wire support are correctly located to sit on the
ledges on the sides of the cavity.
6.
Also note the position of the thermostat phial in its clips.
Service Manual UK
32 of 39
English