A-Neutronics ANI-17015ASUR Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Распределение питания переменного тока A-Neutronics ANI-17015ASUR. A-Neutronics ANI-17015ASUR 7 страниц. 9-outlet rack-mountable power conditioner w/ built-in power meter

Печатать страницу

FEATURES

• Power Monitoring Display:

plugged into an AC power source and the power is turned on, the backlit display will show the incoming voltage and will remain on

until the Function button is pressed. The power meter has (8) meter functions; Voltage, Amperage, Watts, VA (apparent power),

Hz (frequency), PF (power factor), kWh (kilowatt-hour), and Run Time (clock).

• 9-AC Outlets Total:

There are (7) AC outlets on the rear and (2) on the front. The rear (3) and front (2) are "always on". These (5)

outlets are energized the moment the 10' power cord is plugged into an AC outlet. There are LED's above each of these outlets

to indicate they are energized. There are (3) "switched filtered" and (1) "switched high current" outlets. These switched outlets

respond to the front panel power button (labeled: "Switch" on the front panel).

• Isolated Banks:

Linear EMI/RFI Noise Filtration with Isolation between Outlet Banks. Your electronic components are constantly

being subjected to electromagnetic interference (EMI) and radio frequency interference (RFI) through their AC power source.

These types of interference can cause degradation of the overall performance of your entire system. Common symptoms of

interference include loss of picture detail, dull colors, pops, hisses, hums and other artifacts. The ANI-17015ASUR is designed to

eliminate these types of interferences and provide clean power to your equipment.

• Linear Filtering Technology (LiFT):

noise across the entire bandwidth, ensuring peak audio and video performance by reducing harmonic distortion and improving

the signal-to-noise ratio. With LiFT, you are assured consistent performance and the highest resolution from any audio or video

system.

• Cable/ Antenna / Satellite as Well as Telephone and LAN Line Protection:

quality from our new coaxial protectors that have the smallest signal loss on the market - less than 0.5 db of attenuation from 0Hz

to 3.0GHz. Our upgraded coaxial protection has been specifically designed to virtually eliminate signal loss. The clamping level of

75V will meet the demands of both cable and satellite voltage while minimizing exposure to damaging spikes and surges.

The ANI-17015ASUR provides telephone protection on one set of RJ-11 jacks. The telephone line protection circuitry utilizes

solid-state SIDACtors for reliability and unsurpassed protection. The clamping level of the ANI-17015ASUR's telephone protector

is 260 volts. This will allow typical ring voltage (90-130VAC) and operating battery voltage (-48DC) to pass through the circuit and

still protect modems from damage.

Protection circuits are also provided for 10/100 BASE-T Ethernet lines. Incoming LAN line MUST be plugged into the

"Network IN" jack. Patch cord to the equipment MUST be plugged into the "Network Out" jack. All 8 wires are protected

with 6.8V clamping.

The built-in power meter shows (8) different values for all (9) outlets. When the power strip is first

For improving picture and sound quality nothing filters AC noise better. LiFT evenly eliminates

Coaxial protection circuits achieve optimum signal