AEG AGN71800C0 Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера AEG AGN71800C0. AEG AGN71800C0 20 страниц.

Печатать страницу

www.aeg.com

Problem

The compressor does not

start immediately after

pressing the FROSTMATIC,

or after changing the tem-

perature.

Water flows on the floor.

Temperature cannot be set.

DEMO appears on the dis-

play.

The temperature in the ap-

pliance is too low/too high.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

7.2 Closing the door

1. Clean the door gaskets.

Possible cause

This is normal, no error has

occurred.

The melting water outlet is

not connected to the

evaporative tray above the

compressor.

The FROSTMATIC or

COOLMATIC function is

switched on.

The appliance is in demon-

stration mode.

The temperature regulator

is not set correctly.

The food products' tem-

perature is too high.

The door has been

opened often.

The FROSTMATIC function

is switched on.

There is no cold air circula-

tion in the appliance.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

Solution

The compressor starts after a

period of time.

Attach the melting water out-

let to the evaporative tray.

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Keep the OK pressed for ap-

proximately 10 seconds until a

long sound is heard and dis-

play shuts off for a short time.

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Open the door only if necessa-

ry.

Refer to "FROSTMATIC func-

tion".

Make sure that there is cold air

circulation in the appliance.