AEG S53420CTX2 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера AEG S53420CTX2. AEG S53420CTX2 24 страницы.
Печатать страницуProblem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
The temperature in the ap-
pliance is too low/too high.
Possible cause
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC function
is switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent wa-
ter from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
Many food products were
stored at the same time.
The FROSTMATIC function
is switched on.
ENGLISH
Solution
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
The compressor starts after
some time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Refer to "FROSTMATIC func-
tion".
9