AEG SANTO C 7 18 40-4I Инструкции по эксплуатации и установке - Страница 14

Печатать страницу

AEG SANTO C 7 18 40-4I Инструкции по эксплуатации и установке

Should the lining up of the furniture

door be necessary, use the clearance

of slots.

At the end of operations, it is neces-

sary to check if the door of the fur-

niture closes properly.

Fix cover (D) on guide (B) until it cli-

ps into place.

If the appliance is fixed to the

side of the kitchen unit, simply

slacken the screws in the fixing

brackets (E), move the brackets as

shown in the figure and re-tight-

en the screws.

PR168

PR167/1

D735

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-

ply voltage and current values correspond with those of the mains at the

installation location.

e.g.:

220 ... 240 V

220 ... 240 V~

50 Hz

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

A correctly installed, earthed socket is required for the electrical supply. The

supply must have a fuse rating of at least 10 Amps.

If the socket is not accessible once the appliance is built in, the electrical

installation must include suitable means of isolating the appliance from the

mains (e.g. fuse, cut-out, current trip or similar with a minimum contact

separation of 3 mm).

Attention: The mains connection cable may only be replaced by a skilled

electrician. Please contact your dealer or our customer service department

for repairs.

Prior to Initial Start–Up

• Please clean the appliance interior and all accessories prior to initial start-

up (see section: "Cleaning and Care").

Starting up and temperature regulation

0 Insert the plug of the connection lead into the plug socket with protecti-

ve earth contact. When the refrigerator compartment door is opened, the

internal lighting is switched on. The temperature selector knob is located on

the RH side of the refrigerator compartment.

Setting „0" means: Off.

Setting „1" means: Hightest temperature, (warmest setting).

Setting „6" (end-stop) means: Lowest temperature, (coldest setting).

However, the exact setting should be chosen keeping in the mind that the

temperature inside the refrigerator depends on:

-the quantity of food stored

-how often the door is opened

50 Hz or