AEG 341 D Руководство по эксплуатации и установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Вентиляционная вытяжка AEG 341 D. AEG 341 D 21 страница.

For the installer

• When used as an extractor unit, the hood must be fitted with a hose

having preferably the same diameter as the outlet hole.

Should there already be a pipe of diameter 100 mm that ducts to

the outside through the walls or roof, it is possible to use the 100/

125 mm reduction flange provided. In this case the hood will be

slightly noisier.

Attention: The hose is not supplied and must be purchased

separately.

• When installing the hood, make sure you observe the following

minimum distance from the top edge of the cooking hob/ring

surfaces:

electric cookers

gas cookers

If the instructions for installation for the gas hob specify a greater

distance, this must be adhered to.

• The national Standard on fuel-burning systems specifies a

maximum depression of 0.04 mbar in such rooms.

• The air outlet must not be connected to chimney flues or

combustion gas ducts. The air outlet must under no circumstances

be connected to ventilation ducts for rooms in which fuel-burning

appliances are installed.

• The air outlet installation must comply with the regulations laid down

by the relevant local authorities.

• When the unit is used in extraction mode, a sufficiently large

ventilation hole must be provided, with dimensions that are

approximately the same as the outlet hole.

• National and regional building regulations impose a number of

restrictions on using hoods and fuel-burning appliances connected

to a chimney, such as coal or oil room-heaters and gas fires, in the

same room.

• Hoods can only be used safely with appliances connected to a

chimney if the room and/or flat (air/environment combination) is

ventilated from outside using a suitable ventilation hole approxi-

mately 500-600 cm

being created during operation of the hood.

• If you have any doubts, contact the relevant controlling authority or

building inspector's office.

• Since the rule for rooms with fuel burning appliances is "outlet hole

of the same size as the ventilation hole", a hole of 500-600 cm

which is to say a larger hole, could reduce the performance of the

extractor hood.

500 mm

700 mm

large to avoid the possibility of a depression