AEG 9000 Series Руководство пользователя - Страница 40
Просмотреть онлайн или скачать pdf Руководство пользователя для Вентиляционная вытяжка AEG 9000 Series. AEG 9000 Series 48 страниц.
Также для AEG 9000 Series: Руководство пользователя (32 страниц), Руководство пользователя (8 страниц)
Печатать страницу
40
www.aeg.com
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
15.12 Frost precautions
If the appliance is installed in an area
where the temperature can reach the
values around 0° C or drop below,
remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
16. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
16.1 Alarm Codes and Possible failures
The appliance does not start or it stops during operation. First try to find a solution to the
problem (refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the
Start/Pause button may flash continuously:
If the appliance is overloaded, remove some items
from the drum and/or keep pressed the door while
touching the Start/Pause button until the indicator
Problem
stops flashing (see the picture below).
Possible solution
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.