Kohler 12959-4 Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Сантехническая продукция Kohler 12959-4. Kohler 12959-4 3 страницы. Odeon wall-mount bath & dual shower faucet

Печатать страницу

OPERATION INSTRUCTIONS

Lift the handle slightly to turn on the faucet. Turn to vertical position for cold water, horizontal position for hot

water. Water flows out from spout when faucet diverter is in the normal position and it's diverted to shower

column when the diverter knob is lifted.

Turn the diverter handle to the vertical upwards, water will flow from the handspray; turn it to the vertical

downwards, the showerhead will work; turn it to the position between the vertical upwards and the vertical

downwards, water will flow the showerhead and the handspray.

INSTALLATION CHECKOUT

Ensure that all connections are tight. Ensure that the handle is in the

off position.

Turn on the drain and main water supply, and check for leaks. Repair

as needed.

Remove the aerator assembly(34). Run hot and cold water through

spout about one minute to remove any debris. Clean the aerator

assembly. Shut off the faucet. Reinstall the aerator assembly.

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean

soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

1124477-2A-G

INSTALLATION INSTRUCTIONS

12959-4

BEFORE YOU BEGIN

All information is based on the latest product information available at the time of publication. Kohler Co.

reserves the right to make changes in product characteristics, packaging, or availability at any time without

notice.

Please leave these instructions for the consumer. They contain important information.

NOTES:

1. Shut off the water supplies to the fitting.

2. Inspect the supply tubing for damage. Replace as necessary.

3. Observe local plumbing codes.

4. The minimum inlet water pressure for diverter is 0.05MPa(0.5bar).

5. Recommended minimum working pressures is 1bar(0.1Mpa).

6. The highest working pressure for showerhead & handspray is 0.5MPa(5bar). If it exceeds 0.5MPa(5bar), a

pressure reducer is needed. The highest water and environment temperature is 60°C. Please keep

handspray showerhead and the shower arm away from heater, or it may become damaged and cause injury

to the user.

ROUGH-IN DIMENSIONS

G1/2˝

Finished Floor

1124477-2A-G

Wall-Mount Bath & Dual Shower Faucet

72704-4 Wall-Mount Bath & Dual Shower Faucet

400

Ø145

155

Four-way Handspray

(Only for 12959-4)

G1/2˝

150

G1/2˝

Ø102

G1/2˝

Only for 72704-4

G1/2˝