AEG mintie ECU4 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Вентиляционная вытяжка AEG mintie ECU4. AEG mintie ECU4 17 страниц.

Part I: Construction/Maintenance & the Sidewall Access Flange Accessory

A. Anteroom for Construction Projects and Surge Isolation Response

& B. Construction — Wall Containment Projects

To use the ECU4 as an entry/exit air lock chamber f or construction areas: providing Class 4 ICRA containment.

1. Open ECU4 according to previous instructions and position against the construction area doorway or

entrance opening. Secure against ceiling according to previous instructions.

2. From inside ECU4 unzip a wide cargo door and stow. Zip a (Optional) Sidewall Flange accessory in it's place.

Roll up door and stow using hanging Velcro straps on either inside or outside of unit. (Doors may be

detached and reattached as necessary.) Begin to apply a roll of self adhesive Velcro (provided) to the

door frame; making a box frame including the threshold oor of the doorway. NOTE: It is very important

to ensure that the entire ange edge is secured against the door frame and oor so that no gaps exist that

might allow infectious particulates an opportunity to escape. Be careful to not impede the closing

of any door. (Fig. I-A-1)

3. Apply the edge of the Sidewall Access Flange; sewn Velcro edge, to the Velcro frame on the doorway. Start

in the middle of the door frame top and work your way into the corner folding excess envelope if any onto

itself, (FIG.1-A-2). From inside the ECU4 open the 12.5" negative air port by rolling down t he Velcro Flap.

4. Attach HEPA- ltered negative air machine by inserting ex duct into the 12.5" port on exterior of unit.

For increased exibility in work projects, you may switch the negative air ports panel to the other

side of the unit.

5. Tighten the draw strings to seal port around the negative air machine ex duct and/or HEPA vacuum hose.

Ensure there are no gaps that may allow potentially infectious particulates an opportunity to escape

the draw of the machine. (Fig. I-A-3)

6. Open pressure relief vents, as needed, located inside envelope, beneath windows on both short

doors, and the non- ange side door. Turn on HEPA- ltered negative air machine to low setting. As the

air pressure inside the unit lowers, the sides of the unit will begin to be drawn in.

7. Follow established infection procedures for entry and exit of containment areas. NOTE: The ECU4 can utilize

the ECU Corridor Flange to create an airlock access point across an entire corridor. (Fig. I-A-4)

(Fig. I-A-4)

(Fig. I-A-1)

(Fig. I-A-2)

Disposable (DE) are interchangeable with your ECU4

frame.

Whether for dirty work that you don't want to clean

up or a counter measure to provide a standard

against units from contractors that you are not

confident in; eliminate the risk in your critical envi-

ronments and go DE!

www.mintie.com

ECU4 APPLICATIONS

(Fig. I-A-3)

1-800-9MINTIE

1-323-225-4111

Anteroom/Airlock

(Fig. I-A-4)