Kohler BodySpa K-1000 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Kohler BodySpa K-1000. Kohler BodySpa K-1000 28 страниц. Tower custom hydro-massage system
Также для Kohler BodySpa K-1000: Руководство для домовладельцев (48 страниц)
1. PRODUCT NOTICES
A. INSTALLER HAZARD NOTIFICATION
WARNING: Risk of electrical shock. A licensed
electrician should make all electrical connections.
WARNING: Risk of electrical shock. Connect only
to
a
circuit
protected
Circuit-Interrupter (GFCI).
WARNING: Risk of electrical shock. Disconnect
power before servicing.
WARNING: Risk of injury or property damage.
Please read all instructions thoroughly before
beginning installation, including the following
Product Requirements.
NOTICE: Follow all local plumbing and electrical
codes.
C. PRODUCT MODIFICATIONS
All information in this manual is based upon the latest
product information available at the time of publication.
Kohler Co. reserves the right to make changes in product
characteristics, packaging, or availability at any time
without notice.
WARNING: Unauthorized modification may
cause unsafe operation and poor performance
of the BodySpa. Do not relocate the pump or make
other modifications to the BodySpa system, as this
could adversely affect the performance and safe
operation of the unit. Kohler Co. shall not be liable
under its warranty or otherwise for personal injury or
damage caused by any such unauthorized
modification.
The BodySpa is not designed for steam applications, and
may not perform satisfactorily as a steam unit.
2. PRODUCT REQUIREMENTS
A. PRODUCT INSPECTION
The BodySpa door enclosure, footbath, and tower are
specifically designed for this installation. Before
proceeding with the installation, check the model
numbers of the footbath, tower, and door enclosure. The
door enclosure, tower, and footbath model numbers are
provided in the roughing-in information packed with the
product.
Carefully unpack and inspect the footbath and tower for
damage. Do not unpack the door enclosure until
instructed to do so. Leave all materials in the cartons
during construction to prevent damage.
NOTICE: Make sure the union connection to the
pump inlet is securely tightened.
AB
116290-2-
by
a
Ground-Fault
2
B. FACTORY-ASSEMBLED FEATURES
Factory installed components include pump with integral
heater, control, and power supply cord.
The pump and piping are factory-assembled.
B. CONNECTIONS AND SERVICE ACCESS
Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to the
pump. An access panel must be constructed to allow for
sufficient clearance for servicing the pump or controls.
The access panel must be located immediately next to the
pump. Refer to the roughing-in information packed with
the product and the stud framing preparation on Page 3.
Kohler Co., Kohler WI U.S.A.