Kohler Elosis 18077T-B-CP Руководство по установке - Страница 10
Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Kohler Elosis 18077T-B-CP. Kohler Elosis 18077T-B-CP 12 страниц. Sensor faucet
Печатать страницу
用户须知（续）
如图示:
(1) 快速闪烁，代表感应龙头正处于通电后
的两分钟自动调节阶段。期间，安装者、使
用者不得干扰其自动调节，感应范围内不要
放置物体。
(2) 间隔6秒钟闪烁一次（直流版本），表
示电池即将使用完，请更换电池。
(3) 间隔2秒钟连续闪烁：若直流感应龙头,
代表龙头电池耗尽，已停止工作，等待使
用者更换电池;若交流感应龙头，表示为两
种情况：一种为刚刚停电；另一种为在交
流供电正常的情况下，则电源盒直流接线
端接触不良。
(4) 在正常工作情况下，当有物体被感应
时，龙 头出水，感应指示灯闪烁一次 。
(龙头关闭，感应指示灯不闪烁）
2.
超时出水控制
连续在感应状态下使用约一分钟，龙头自动止水。
自动止水后，手或物体离开感应范围后，再次进
入感应范围内，龙头正常工作，否则无反应。
3. 清洗过滤系统
该感应龙头的控制组件内已包含了过
滤装置。如管内杂质过多或水质较
差，长期使用会引起出水情况不良。
请按以下步骤清洗过滤装置：
1 关闭角阀。
2 将控制组件进水口处软管拧下，取出
滤网组件，用水冲洗完毕后，重新装
入。
10
IMPORTANT CONSUMER INFORMATION
(Continued)
指示灯
Indicator Light
2. Timeout setting
When the faucet works for about continuous 1 minute, the
faucet will stop flushing automatically. After that, objects
must be removed from the sensing range. Then the water
will flow when objects enter into the sensing range again.
Otherwise, the faucet will not work.
滤网组件
混水(Mixer): 18055T-B-CP,
18075T-B-CP, 18076T-B-CP
滤网组件
单冷(Cold):18057T-B-CP,
18077T-B-CP, 18078T-B-CP
As shown:
(1) Quick flashing means the faucet is in the
period of adjusting sensing distance after power
on for 2 minutes. During these 2 minutes, please
do not disturb auto adjustment, no objects shall be
put in the sensing range.(2) The indicator flashes
every 6s (DC type) indicates that the unit is
out of battery and ceases working. please replace
batteries.
(3) The indicator flashes every 2s: as for DC type
faucets, this indicates the unit is out of battery and
ceases working. Please replace batteries. For AC
faucet, it indicates two possibilities: one is that
the unit is just out of battery; or poor DC terminal
contact under normal AC power supply.
(4) Under normal condition, the water will flow and
the indicator will flash once when objects are
detected. (The indicator does not flash when
faucet stops flowing.)
3.
Clean the Filtration System
The touchless faucet control assembly include
filtration device. Poor water outflow shall be
caused by excessive impurities inside the hose
or poor water quality after long time use. Please
clean filtration device per following steps:
Turn off stop valve.
1.
2.
Pull hose from control assembly water inlet,
take filter screen assembly out. Reinstall screen
after clean by water.
1248536-T01-C