Kohler K-1018 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Kohler K-1018. Kohler K-1018 40 страниц. Shower modules and receptors
Также для Kohler K-1018: Руководство для домовладельцев (8 страниц)

Печатать страницу

Note: If the showerhead

trim ring is larger than 3"

(7.6cm), it is recommended

that the showerhead be

installed above the top

edge of the shower unit if

space allows.

5. Mark and Cut the Water Supply Holes

CAUTION: Risk of injury. Wear safety glasses while cutting or drilling.

CAUTION: Risk of product damage. Check and recheck the valve and showerhead locations before drilling.

The hole(s) must be in the correct location.

- Mark the center of the supply valve on the front side of the end wall. Determine the height according to the

manufacturer's instructions.

- The holes should align with the rough plumbing established in step 1, and should be on the centerline of the wall

panel at the correct distances from the floor.

- Refer to the valve manufacturer's instructions for proper hole size. Make sure the valve cover plate is large

enough to cover the holes.

- Drill 1/4" (6mm) diameter pilot holes at the marked locations on the appropriate shower wall.

- From the finished surface of the wall, cut the holes required for the valving. A hole saw is preferred, but if the

correct size is not available it can be cut using a sabre- saw with a fine metal or plastic cutting blade.

- Protect the finished surface with masking tape before cutting.

1024937-2-

Water Supply

Valve Hole

Cut the valve stem hole(s) from

the front of the wall panel

Note: When determining the valve cut- -out

location, measure the distance from the

top ledge of the receptor.

Pilot Hole

Kohler Co.