Kohler K-1244 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Kohler K-1244. Kohler K-1244 48 страниц. Bath whirlpool
Также для Kohler K-1244: Руководство для домовладельцев (32 страниц), Руководство для домовладельцев (29 страниц), Руководство по установке (48 страниц), Руководство для домовладельцев (36 страниц), Руководство для домовладельцев (32 страниц), Руководство по установке (48 страниц), Руководство по установке (48 страниц), Руководство по установке (44 страниц), Руководство по установке (44 страниц), Руководство для домовладельцев (29 страниц), Руководство по установке (48 страниц)

Печатать страницу
Kohler K-1244 Руководство по установке

5. Secure the Whirlpool

Wood Construction
Drill a small pilot hole through the nailing-in flange at each stud. Add shims between the nailing-in
flange and the studs as needed to eliminate gaps.
Nail 1/4" (6 mm) thick furring strips to the studs to shim out to the edge of the nailing-in flange.
Use #6 large-head galvanized nails to secure the nailing-in flange to the studs.
Concrete Construction
NOTE: We recommend that the flange be secured to the wall for support.
Drill pilot holes through the nailing-in flange so they are about 16" (40.6 cm) apart.
Install concrete wall anchors to the wall at the pilot hole locations.
Secure the nailing-in flange to the wall anchors with screws.

6. Install the Plumbing

WARNING: Risk of property damage. Ensure a watertight seal on the bath drain.
Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
Install the faucet valving according to the faucet manufacturer's instructions. Do not install the
faucet trim until instructed. Open the hot and cold water supplies, and check the supply
connections for leakage.
Run water into the bath, and check the drain connections for leakage.
1040292-2-E
Nail 1/4" (6 mm)
thick furring strips
to the studs.
Stud
Use #6 large-head
galvanized nails to secure
the nailing-in flange to the
studs.
Drill a small hole
through the nailing-in
flange at each stud.
8
Kohler Co.