Kohler K-1257 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Сантехника Kohler K-1257. Kohler K-1257 44 страницы. Bath whirlpool
Также для Kohler K-1257: Руководство для домовладельцев (32 страниц), Руководство для домовладельцев (29 страниц), Руководство по установке (48 страниц), Руководство для домовладельцев (36 страниц), Руководство для домовладельцев (32 страниц), Руководство по установке (48 страниц), Руководство по черновой отделке (4 страниц), Руководство по черновой отделке (4 страниц), Руководство по установке (48 страниц), Руководство по черновой отделке (4 страниц), Руководство по установке (48 страниц), Руководство по установке (44 страниц), Руководство для домовладельцев (29 страниц), Руководство по черновой отделке (4 страниц), Руководство по установке (48 страниц)

Печатать страницу
Kohler K-1257 Руководство по установке

5. Cut the Pump Banding Straps

NOTE: If your pump model does not have banding straps, proceed to the next section.
IMPORTANT! This step is necessary to make your Kohler whirlpool operate more quietly.
NOTE: Do not raise the pump higher than it was before you cut the pump banding straps. If the pump is
raised too high, it will not prime properly.
Use tin snips to cut the two pump banding straps. When the banding straps are cut, the pump
support bracket and pump will drop about 1/2" (1.3 cm) until they rest on the subfloor. If the pump
drops more than 1/2" (1.3 cm), shim under the pump support bracket so there is a 1/2" (1.3 cm)
gap between the pump and bracket to allow for proper drainage.
To minimize whirlpool noise and vibration, be sure the pump is not in direct contact with the
shipping bracket after the pump banding straps are cut.
Secure the pump support bracket to the subfloor with screws or lag bolts (not provided).

6. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
Install the faucet valving according to the faucet manufacturer's instructions. Do not install the
faucet trim until instructed. Open the hot and cold water supplies, and check the supply
connections for leakage.
Run water into the whirlpool, and check the drain connections for leakage.
1010914-2-D
Suction Line
Drainage
NOTE: Pump model illustrated may differ from your
actual product.
Pump
Cut the pump
banding straps.
8
Kohler Co.