AEG LAVATHERM 65771IH1 Руководство пользователя - Страница 15

Просмотреть онлайн или скачать pdf Руководство пользователя для Сушилка AEG LAVATHERM 65771IH1. AEG LAVATHERM 65771IH1 24 страницы.

AEG LAVATHERM 65771IH1 Руководство пользователя
Child lock option activation:
1. Turn the dryer on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Push and hold down the Time
Drying and Delay Start buttons at
the same time.
The symbol
5. To deactivate the child lock, press
the above buttons again until the
symbol disappears.
9.8 Starting a programme
To start the programme:
Push the Start/Pause button.
The appliance starts and the LED above
the button stops flashing and stays on.
9.9 Programme change
To change a programme:

10. HINTS AND TIPS

10.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
appears on the display.
1. Turn the programme dial to Stop
position.
2. Set a new programme.
9.10 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle has finished, the
symbol
flashes on the display. If the
Buzzer option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2
seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10.2 Adjustment of dryness
levels
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Push and hold down the Anticrease
and Time Drying buttons at the
same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
5. Push the Start/Pause button
repeatedly until you reach the
desired dryness level.
ENGLISH
15