Kohler TAUT 74026T-4 Инструкции по установке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по установке для Сантехника Kohler TAUT 74026T-4. Kohler TAUT 74026T-4 2 страницы. Single lever lavatory faucet

Печатать страницу

18°

100

Ø33~Ø36

G1/2˝

INSTALLATION

1278331-2A-B

Ø54

Ø36.5

Ø31.75

74013T-4

How to Install the Spout

Install the mounting stud(2) onto the faucet body

base(3). Insert lift rod(5) to the hole at the rear of the

body. Slide the washer(4) over the flexible hoses(1),

lift rod and mounting stud, and into the groove at the

bottom of the faucet body.

Insert the faucet assembly into the lavatory hole.

Position the faucet. From underside of the lavatory,

place the bracket(6, Rubber washer is on the top)

onto the mounting stud, and tighten the nut(7) by

tool(8) to secure the faucet.

Attach the hoses to water supplies. When facing front

of the faucet , the left hose connects to hot water, the

right hose with "COLD" label connects to cold water.

How to Install the Drain

Remove stopper(12), flange(9) and washer(10) from

drain body(11). Insert drain body kit into the lavatory

from underside, and make sure the drain lever

hole(15) facing to the back of the lavatory. Screw the

flange with washer into the drain body. Tighten the

locknut(14) by hand from the underside of the fixture.

NOTE: If needed, apply a ring of plumbers putty

around the underside of the drain flange(9), instead of

using washer(10).

Place stopper(12) into drain body aligning the flat side

of stopper hole(13) with the drain lever hole.

INSTALLATION CHECKOUT

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely

affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

1278331-2A-B

Remove the retaining nut(17). Fit the plastic

washer(18) and retaining nut onto the ball lever(19).

Insert the ball lever assembly into the drain lever hole

and through the stopper hole. Tighten the retaining

nut.

Be sure that the ball lever(19) points to the back of the

lavatory, tighten the locknut(14) on the drain body by

wrench.

NOTE: Do not reposition the drain if plumbers putty

applied after the locknut is tightened, or you may

break the putty seal. Wipe away excess plumbers

putty.

Assemble thumb screw(20) to link(21), and link onto

ball lever(19) with 'V'-clip(16). Slide lift rod(5) into the

hole in link.

Push the ball lever down into the open position, and

adjust the lift rod. Tighten thumb screw(20).

Ensure that all connections are tight. Ensure that the

handle is in the off position. Turn on the drain and

main water supply, and check for leaks. Repair as

needed.

Remove the aerator(22) by coin. Turn on the faucet.

Run hot and cold water through the spout for about

one minute to remove any debris. Remove debris from

the aerator. Shut off the faucet and reinstall the

aerator.