Kohler K-1144 Руководство по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке для Ванны Kohler K-1144. Kohler K-1144 44 страницы. Bath whirlpool
Также для Kohler K-1144: Руководство для домовладельцев (32 страниц), Руководство по установке (48 страниц), Руководство по установке (44 страниц), Руководство по установке (48 страниц)

Whirlpool

10. Complete the Finished Wall

NOTE: If your whirlpool has an integral apron, it is designed so the ﬁnished wall material (1-1/2" [3.8 cm]

maximum) will overlap the apron columns. The ﬁnished ﬂoor material (2" [5.1 cm] maximum) should butt

against the apron.

If you have not already done so, carefully remove the protective tape from the whirlpool rim.

If necessary allow for deck-mounted valves and spout.

Cover the framing with water-resistant wall material. Seal the joints between the whirlpool rim edge

and the water-resistant wall material with silicone sealant.

Tape and mud the water-resistant wall material. Install the ﬁnished wall to the water-resistant wall

material. Seal the joints between the whirlpool rim and the ﬁnished wall material with silicone

sealant.

Install the faucet trim according to the trim manufacturer's instructions.

Your whirlpool may be equipped with an integral apron which allows you convenient access to

your whirlpool controls. To remove the apron, insert the edge of a ﬂat blade screwdriver or dull

knife under the edge of the apron panel. Be careful not to scratch the visible surfaces. Gently pry up

at one end. Carefully pull the apron panel off.

To reinstall, bow the apron slightly so both ends can be inserted at the same time. Gently press in

the center of the panel to secure the apron in place.

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. Use warm water and a liquid detergent to clean the surface.

Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners

containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods

of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire

brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild

abrasive action to any residual plaster.

1011092-2-F

Framing

Water-Resistant

Wall Material

Finished Wall

Apply silicone sealant to the

joint between the whirlpool

and the finished wall.

On models with an integral apron,

access the pump by gently prying

at the apron edge with a

screwdriver or dull knife to remove.

Kohler Co.