Kohler Command PRO CH620 Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Двигатель Kohler Command PRO CH620. Kohler Command PRO CH620 10 страниц. Vertical/horizontal crankshaft
Также для Kohler Command PRO CH620: Руководство пользователя (21 страниц), Руководство пользователя (8 страниц), Руководство пользователя (24 страниц), Руководство пользователя (8 страниц)
Печатать страницу
Maintenance lnstructions
1
11
AwARNING
Before working on engine or equipment, disable
~
Accidental Starts can cause
engine as follows: 1) Disconnect spark plug
severe injury or death.
lead(s). 2) Disconnect negative(-) battery cable
~
. Disconnect and ground spark
from battery .
plug lead(s) before servicing.
Normal maintenance, replacement:onepair of emission control devices and systems may be
rierformed by any repair establishment or individual; however, warranty repairs must be performed
1y a Kahler authorized dealer found at KohlerEngines.com or
1-800-544-2444
(U.S. and Canada).
• Replace low-profile air cleaner element.
• Change oil.
• Remove cooling shrouds and clean cooling areas.
• Chec!< oil cooler fins, cle~n as necessary (if equipped).
• Have crankshaft spline lubricated.
1
1
Perform these procedures more frequently under severe, dusty, dirty conditions.
2
Have a Kahler authorized dealet perform this service.
.
11
Recommendat,ons
••re recommend use of Kahler oils for best
3rformance. Other high-quality detergent
uds (including synthetic) of API (American
Petroleum Institute) service class SJ or higher
·e acceptable. Select viscosity based on air
mperature at time of operation as shown in
table below.
Check Oll Level
NOTE: . To prevent extensive engine wear or
damage, never run engine with oil level
below or above operating range
indicator on dipstick.
·
Ensure engine is cool. Clean oil fill/dipstick
areas of any debris.
1.
Remove dipstick; wipe oil off.
a. Press-in cap: reinsert dipstick into tube;
press completely down.
or
b. Thread-on cap: reinsert dipstick into
tube; rest cap on tube, do not thread cap
onto tube.
2. Remove dipstick; check oil level. Level
should be at top of indicator on dipstick.
3. lf oil is low on indicator, add oil up to top of
indicator mark.
4. Reinstall dipstick and tighten securely.
EN