Kohler K91 Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Двигатель Kohler K91. Kohler K91 8 страниц. Horizontal crankshaft
Также для Kohler K91: Руководство по эксплуатации и техническому обслуживанию (17 страниц), Руководство пользователя на нескольких языках (8 страниц)

Печатать страницу

INSTALLING THROTTLE WIRE

GOVERNOR ADJUSTMENT

The governor functions to maintain engine speed under changing load conditions and also acts as

a speed limiting device.

(ar row indicates direction to decrease speed).

cable is inserted is also important as this establishes degree of governor control.

permanently mark the exact position of the throttle bracket (scribe mark on crankcase) and also the

control disc hole in case linkage becomes disconnected or bushing or arm retaining nuts work loose.

If this is done, the governor can be quickly reset to original position.

Initial Adjustment:

arm retaining nut, grasp end of cross shaft in pliers and turn in counterclockwise direction until shaft

stops internally.

buretor (with updraft type carburetor, lift arm as far as it will go) and retighten arm nut to complete

initial adjustment.

Cable Installation:

Wlre exactly as shown in inset--if carelessly hooked or looped, wire will bind on control disc and cause

poor governor - action.

hole nearest to throttle bracket.

Speed Adjustment:

check top speed with hand tachometer.

most other models it is

in clockwise direction.

binding of the cross shaft).

STORAGE INSTRUCTIONS

Drain oil from crankcase (while hot) then flush with clean light oil.

Drain fuel from tank, sediment bowl and carburetor.

of oil over surfaces subject to corrosion (unpainted metal surfaces).

plug hole, turn engine over several times by hand then reinstall plug.

place.

The position of the throttle bracket determines speed range of the engine

This is made (with engine stopped) as follows:

Hold cross shaft in this position, then pull governor arm all the way away from car

If throttle cable becomes disconnected, use following procedure:

Move throttle control handle to open position then insert wire into control disc

After readjusting governor, restart engine then move throttle to open position and

Maximum permissible speed for

RPM.

To decrease speed, loosen bushing nut and move throttle bracket

3600

Retighten bushing nut after adjustment (Do not overtighten--this could cause

Use the following procedure to preserve engine before placing in storage.

CONTROL

DISC

�

THROTTLE

WIRE

Arrow indicates ditection to

move bracket to decrease speed.

GOVERNOR COMPONEN TS

The hole in the control disc into which the throttle

Loosen (do not remove) governor

Refili crankcase after flushing.

Clean exterior of engine then spread light film

Pour tablespoon of oil into spark

Cover engine and store in dry

GOVERNOR

ARM

BUSHING N UT

is a good idea to

Bend end of throttle

RPM while for

K91

4000