Kohler 275548 Инструкции

Просмотреть онлайн или скачать pdf Инструкции для Портативный генератор Kohler 275548. Kohler 275548 4 страницы. Throttle repair kits for generator sets

Печатать страницу

Throttle Repair Kits --- 275547, 275548, 275549, 275550

The throttle repair kits replace the governor

throttle spring with a linkage or bracket which

holds the governor throttle lever in the

full---open position. (See Service Bulletin 496.)

Observe the following safety precautions during

kit installation.

Reference the appropriate

installation drawing to identify and assemble

components.

WARNING

Accidental starting can cause death or serious

personal injury. Turn Generator Master Switch

to OFF position, disconnect power to battery

charger, and remove battery cables (remove

negative lead first and reconnect it last) to

disable generator set before working on any

equipment connected to generator.

generator set can be started by automatic

transfer switch or remote start/stop switch

unless these precautions are followed.

WARNING

Exposed moving parts can cause severe injury.

Keep hands, feet, hair, and clothing away from

belts and pulleys when unit is running. Replace

guards, covers, and screens before operating

generator set.

for 20---180 ROZJ Generator Sets

Standby Generator Sets

The

CAUTION

Hot parts can cause personal injury.

Do not touch hot engine parts. An engine gets

hot

while

running

components get extremely hot.

NOTE

Do not adjust governor fast idle adjusting screw

during kit installation. Changing position of fast

idle screw will affect engine speed and require

that the governor be adjusted.

INSTALLATION

1. Disconnect engine battery cables (negative

lead first) to disable generator set.

2. Disconnect spring from governor throttle

lever and spring bracket. Discard spring.

3.1 20---100ROZJ Models

a. Remove hardware securing spring bracket to

engine block. Remove and discard spring

bracket.

Reference

installation drawing in Figure 1 or Figure 2

to determine what hardware should be

retained for installation of new bracket.

b. Attach mounting bracket to engine block

with screws, washers and spacers (if used ---

see parts list). Torque to 28 ft. lbs. (40 Nm).

TT---727

INSTRUCTIONS

7/90

and

exhaust system

the

appropriate