AQC MAXIBENCH MB-3000 Руководство - Страница 9

Просмотреть онлайн или скачать pdf Руководство для Промышленное оборудование AQC MAXIBENCH MB-3000. AQC MAXIBENCH MB-3000 12 страниц.

Печатать страницу

Downdraft work benches and tables

8.4

Sparks Baffle Trays

•

Spark baffle trays can be used dry, with water or sand depending on the table's application.

Once a week a visual inspection should be done and trays emptied.

•

Sludge may form upon contact of dirt and dust and should be removed before hardening.

Removal of sludge may be performed with a spatula, and then the pans can be hosed down.

•

Handle any contaminants present in the tray similarly to water or sludge. Pressure wash with

hot water & detergent if needed.

Note: Use of water in the spark baffle tray is not suitable for all applications.

8.5

Replacement / cleaning of aluminum spark trap filter

Follow these next steps to clean or replace the aluminum spark trap filter.

Note: The spark trap filter is an important component of the Maxibench unit. Avoid having this

component may result in a fire in the filter cartridge.

1. Remove the punched steel work surface and the trays.

2. Remove the aluminum sparks trap filter.

3 . Wash or brush away dirt in the filter. Ensure you do not damage the mesh fabric.

4. Proceed with a visual inspection for tears or rips. Replace if necessary. Put filter back in place.

MAINTENANCE AND INSPECTION

The chart indicated below shows different inspections and the frequency at which they should be

performed.

Frequency of

inspections

Daily

Downdraft Bench

Metal mesh filter

Weekly

Dust drawer

Filter

Bi-Weekly

to Monthly

Fan / Motor

Components

Examine air outlet for possible dust or smoke

accumulation. Refer to Troubleshooting section.

Metal mesh filters should be pulled out and either blown

out with air (or washed) depending on how dirty they

have become. Similar maintenance is required for spark

baffle trays.

The dust drawer should be emptied. A visual inspection

will allow you to determine the dumping cycle

Inspect the filter. Clean it or replace if needed.

Verify that motor is well intact, bolts are firm, and the

motor base is secured. With the machine off, manually

turn the wheel to ensure no marks are seen. A minor ad-

justment may have to be made by a qualified technician.

Procedures