AQC MAXIHYDRO MS-010 Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Пылесборник AQC MAXIHYDRO MS-010. AQC MAXIHYDRO MS-010 14 страниц.

Печатать страницу
To adjust the working water level, this should be done while balancing the air volume. The water
level greatly influences the air volume, to much water reduces air volume, low water level produces
increased air volume and possibly water bypass.
Water level at static water level, close the inlet water valve (A), start the blower and verify the
air volume if :
•
To much air, increase water level
•
Not enough air, decrease water level
This will provide the working water level. Float valve should be adjusted at (B) for this water level.
To adjust (B) loosen nut and slide up or down the ridged pipe at the desired level.
When the water level drops due to evaporation, the solenoid valve assembly will allow sufficient
water into the unit to bring it back to Working Water Level. If the unit is overfilled, due to the
solenoid valve assembly being jammed, water will escape through the overflow pipe, which is fitted
inside, pass through the overflow reservoir and spill outside the unit.
HIGH LIMIT WATER CONTROL
RAKE-OUT DOOR
OVERFLOW
OUTLET
BY CONTRACTOR
DRAIN VALVE
6
4. Install a ground wire to the unit.
5. Lift the filter cabinet using the lift lugs. Using spikes, position the
WARNING!
Whenever the fan is stopped, the supply of water is turned
off. Similarily, when the fan is turned on, the solenoid valve
opens and maintains the water level automatically.
6. Lower the filter cabinet onto the dust storage section and align th
7. Attach the filter cabinet to the dust storage section using the supp
Figure 3
(B)
UP
DOWN
FLOAT
VALVE
LEVEL
WARNING
Apply two strips of butyl adhesive on the dust storage sec
outline. One strip should be applied inward of the bolt hol
strip outward of the bolt holes (Figure 4).
above the dust storage section making sure to align the cabinet b
with the dust storage bolt holes.
WARNING
The use of a spreader is recommended to avoid
damages to the filter cabinet.
washers and bolts. Tighten bolts for an adequate seal.
SOLENOID
Support
Support
Cross braces
Wet type dust collector
WATER FILL VALVE
plates
Unside bag
WATER INLET
removal
legs
FAST FILL VALVE (A)
FLOAT VALVE (B)
STATIC WATER LEVEL
MAXITUBE
Baghouse D
Fig