A-TOUCH W-Thermo Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Термостат A-TOUCH W-Thermo. A-TOUCH W-Thermo 15 страниц.

USING 2 UNITS WITH 1 THERMOSTAT

As explained above, it is possible to use one thermostat to control 2 different

climatization units. So that this is possible, the slave actuator (REMOTE) must be

associated with the master actuator (LOCAL) that is the unit that is connected with

the thermostat panel.

ASSOCIATING A REMOTE TO A LOCAL UNIT

To associate a remote unit with a local unit proceed as follows:

From this moment on, the units are associated.

Notes:

The remote unit can only be associated with 1 local unit

SELECTING THE UNIT TYPE IN THE REMOTE UNIT

The remote unit must also be configured for the correct unit type it is connected to.

To select it proceed as follows:

OPERATION

The thermostat will operate normally and according to the settings in HEATER unit

and COOLER unit:

With the local unit if LOCAL

With the remote unit if REMOTE

With both units if BOTH

No operation if NONE

The operation is the same if the unit operates with a local, remote or both units.

Press the key

(PROG) on the remote unit to put it in programming

mode:

- the 3 LEDs go ON.

Press now the key

(STBY) on the touch panel of the local unit:

- the 3 LEDs on the remote unit go OFF.

Hold the key

(PROG) on the remote unit for more than 1 second>

- the red LED blinks the number of times as the selected mode:

1 = radiator

2 = radiating floor

3 = airflow2

4 = airflow4

5 = air conditioning

6 = Daikin FDX

Press the key

(PROG) to select the next value.

- the red LED follows the selected type.

Confirm by pressing the key

- the LED goes off.

(TEST).