AQTRONIC THC102MX Руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер AQTRONIC THC102MX. AQTRONIC THC102MX 5 страниц. Cnc plasma torch height controller
Печатать страницуTHC102MX
CNC PLASMA Torch Height Controller
ATTENTION:When connecting directly, use
the shortest possible cables for connecting
the plasma source with THC controller - it is
recommended the THC controller to be lo-
cated directly at the plasma source.
Direct 1:1 plasma cutters
While being a universal THC, accepting full raw arc voltage for most
any plasma cutter on the market, an exciting new standard feature of
this unit is the addition of a 1:50 divider for an extremely fast, simple
installation on most major brands. There will most likely be a direct
connection for this on the outside of the plasma cutter's unit. Please
refer to your plasma cutter owner's manual.
An example of how to connect the THC controller's measurement
input withthe output of the very popular Hypertherm Powermax45
®- The THC comesstandard equipped with a low voltage output of
1:50 divider. This ratio is the most commonly used division in most
major brands and there will most likely be a plug for this connection
on the outside of the cutter's unit.
Example 1:50 Ratio wiring.
Hyprtherm Powermax 45.
For 1:50 Ratio please set the
Jumper to 1:100 mode and use two
resistors 10K 0.25W like the dia-
gram .
2
http://www.aqtronic.com