Aqua 72041 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Системы фильтрации воды Aqua 72041. Aqua 72041 8 страниц. Sand filter system

SAFETY INFORMATION

The sand filters are designed to work with water at temperature>than 0! and <than 45!.The

filter should never be operated outside of these temperatures or damage may occur.

The installation should be carried out in accordance to the safety instructions of swimming

pools and the specific instructions for each facility

The user should make sure that the installation is carried out by qualified authorized persons and

that these persons have first carefully read the following instructions. Incorrectly installed

equipment may fail, causing severe injury or property damage

The operating safety of the filter is only guaranteed if the installation and operation instructions

are correctly followed.

To reduce the risk of injury, do not permit children to use this product.

Chemical spills and fumes can weaken Swimming Pool/ Spa. Corrosion can cause filters and other

equipment to fail, resulting in severe injury or property damage. Do not store pool chemicals near your

equipment.

Any modification of the filter requires the prior consent from the supplier s original replacement parts

and accessories authorized by the manufacturer ensure a high level of safety. The supplier assumes

no liability for the damage and injuries caused by unauthorized replacement parts and accessories.

In the event of defective operation or fault, contact the supplier or its nearest authorized service agent

Sand Filtration working principle

Incoming water from the piping system is automatically directed by the Multiport Valve to the

top of the filter bed. As the water is pumped through the filter sand, dirt and debris are

trapped by the filter bed, and filtered out. The filtered water is returned from the bottom of

the filter tank, through the Multiport Valve and back through the piping system

Preparation before installation

Position the filter as close to the Swimming Pool/ Spa as possible.

The filter should be placed on a level concrete slab, very firm ground, or equivalent. Ensure that the

ground will not subside, preventing any strain from the attached plumbing.

Position the filter under consideration of the piping connections, so that it is convenient for

operating and servicing.

Ensure that the compliance label is facing the front to allow easy identification in the case of service

difficulties.

How to install the filter tank

Put the filter tank on the base, turn right to tight up. Position the outlet drain plug is facing

outside for easy operation.

Before filling the filter media into the filter vessel, do a visual check of the laterals. Replace the

broken or loose laterals if necessary. (The laterals of side-mount valve sand filter are all

installed). And then install the laterals, match the Raised Point of laterals to Folding Umbrella

lateral holder, insert the laterals and turn 90 clockwise, after hearing the sound, the lateral is

well installed. Please refer to the following picture.