A.B.S. Flexilo MINI Инструкции по сборке, эксплуатации и заполнению - Страница 10

Просмотреть онлайн или скачать pdf Инструкции по сборке, эксплуатации и заполнению для Промышленное оборудование A.B.S. Flexilo MINI. A.B.S. Flexilo MINI 19 страниц. For wood pellets. construction: plug-in system galvanized

Печатать страницу

Operating and Assembly Instructions – A.B.S. Flexilo MINI for wood pellets

Room Layout

3.2 Condition of the room

A stable supporting surface as the installation site is a prerequisite for setting up the silo. The

floor must be horizontal; if this is not the case, any unevenness must be corrected through

use of suitable underlay material (e.g.: steel plates). The load-bearing capacity of the floor

has to be checked according to the silo capacity.

For silos up to about 3.1 t, the plates at the bottom of the frame feet (stands) have

dimensions of 120x120 mm; starting at about 3.2 t, the dimensions are 140x140 mm. For

silos with a capacity of 8 t or higher, the load per frame feet (stand) can exceed 2,000 kg;

larger plates are available in such cases. Please consult the manufacturer directly with your

questions in this regard and check the permissible floor loading.

The base connectors must be secured by means of anchor bolts.

Rooms with moisture levels normally found in cellars do not present any problems; however,

condensation must not occur. In case of humidity the room must be ventilated properly. The

silo fabric is air-permeable and may cause the wood pellets to absorb humidity at the silo

walls.

Make also sure that humidity does not enter the filling pipe if it is directed from outside into

the storage area.

When setting up outdoors, the following applies:

A properly levelled and stable concrete foundation must be available for anchoring the frame

feet (stands). The foundation can be designed as a slab with strip footing or as individual

foundations. The silos should be protected against moisture from below. For outdoor

installation, the frame feet (stands) should be galvanized. The silo must be protected from

direct sunlight and the effects of weather (e.g. place in a wood or metal enclosure or a

coating).

3.3 Room fixtures

Room fixtures such as drain pipes, ceiling hooks, water pipes, etc. must already be

considered in the planning phase, or be removed before installing the Flexilo for wood

pellets, if these interfere with the installation and proper operation of the silo.

There must be no sharp or sharp-edged objects near the silo bag. If it is not possible to

remove such objects, they must be covered.

There must be no lamps, lines of any kind, sharp, hot or damp contact surfaces above the

pellet silo.

Subject to technical change

Issue 09/2016

Page 10 of 19