Aqua Cooler CDTT Руководство по использованию и уходу - Страница 6
Просмотреть онлайн или скачать pdf Руководство по использованию и уходу для Диспенсер для воды Aqua Cooler CDTT. Aqua Cooler CDTT 13 страниц.
Печатать страницуoperaTion
After the water bottle has been connected to the water cooler, the unit is ready for use. Turn the power
switch on the back of the unit to ON. The water cooler will start running. First the unit will pump the water
from the water bottle into the cooling and hot tanks, and then the unit's compressor will start to operate.
Press the hot faucet to fill the hot tank. Once water flows from the hot faucet, the red hot tank switch found
on back of the unit can be switched to ON. The first time the water cooler is used, you will have to wait at
least one hour for cold water and 15 minutes for hot water.
• To dispense hot water, slide the hot water handle to the left side and then press the button all the way in.
• To dispense cook (ambient) water, press the center button.
• To dispense cold water, press the cold water button all the way in.
TrouBleShooTing
Problem
The unit does not dispense hot
and cold water.
Unit does not dispense cold
water.
Unit does not dispense hot
water.
Unit is noisy during operation.
Water leaks from the faucet.
Water is dripping out of the
water cooler and onto the floor.
The water being dispensed has
a strange taste.
Your Partner in Cool.
6
Possible Cause
Unit is unplugged.
Main power supply is off.
Damaged water dispenser.
The water bottle cap is not attached
properly to the connector on the water
cooler.
The access door is open.
Over consumption of cold water in a
short time.
System malfunction.
The ventilation around the unit is
insufficient.
The temperature of the water in the water
bottle is too high.
Over consumpation of hot water in a
short time.
System malfunction.
The appliance is not level.
Unit is touching other objects.
The top portion of the faucet has come
loose.
The faucet has been damaged.
The hose connnector is not connected
properly.
The inside hot or water tanks are leaking
The drain cap on the back is not fastened
correctly.
This is not uncommon with new water
coolers. Do not worry, this is not
dangerous to your health.
Remedy
Plug the power cord into an outlet.
Re-establish main power supply.
Replace the dispenser.
Connect properly. There will be a give
when the hose cap slides properly over the
connector.
Close the access door and allow time for
pump to fill the water reservoirs.
Wait for 15 minutes while the water cools
and try again.
Contact Aqua Cooler service team.
Ensure sufficient ventilation space around
the unit.
Ensure the unit is not placed in direct
sunlight or close to other heat sources.
Wait for for 15 minutes while the water heats
and try again.
Contact Aqua Cooler service team.
Place the unit on a level, flat surface.
Ensure the unit is standing free of any
surrounding objects.
Tighten the top threaded portion of the
faucet.
Contact Aqua Cooler service team.
Make sure the hose connector is properly
connected.
Contact Aqua Cooler service team.
Tighten the drain cap. If the sealing silicon
material inside the drain cap is torn or
damaged, then replcae with a new one.
Clean the hose in the dishwasher (top rack
only) or let it soak in dish soap. The strange
taste useually goes away after the first bottle
has been consumed.