Aqua Cooler AC-MW8EBFY-ASM Руководство по использованию и уходу - Страница 4

Просмотреть онлайн или скачать pdf Руководство по использованию и уходу для Система водоснабжения Aqua Cooler AC-MW8EBFY-ASM. Aqua Cooler AC-MW8EBFY-ASM 8 страниц. Wall-recessed bottle filler

Печатать страницу

INSTALLATION CONT.

STEP 2 - PLUMBING CONNECTIONS

Plumbing rough-in and wall opening should be prepared as shown in the rough-in drawing. This

drinking water cooler is designed to be operated at a water supply line pressure of up to 100 PSI

(690kpa). A pressure regulator must be installed in front of the units water inlet if the pressure

(including any posssible pressure spikes) could exceed 100 PSI (690kpa).

Assemble the optional inline filter clip to the chiller as shown XXX

Install stem elbows (provided) on the inline filter.

Place the inline filter in the clip as shown

Mount the VersaFilter II in the location shown on previous page.

Insall stem elbows (provided) on the VersaFilter II

Install ¼" union fittings (provided) on chiller inlet and outlet

Install provided 3/8" O.D. copper tube, strainer, ball valve, and reducer to the building water

supply.

Install tubing as show above

Nove the tubing from the chiller outlet fitting to the solenoid valve inlet fiting should be

insulated (provided).

Your Partner in Cool.

INSTALLATION CONT.

STEP 3 - ELECTRICAL CONNECTIONS

A 2x4 junction box is provided for the installation of a 115V receptable. This unit is intended to

be connected to a ground fauly circuit interuppting (GFCI) device to meet UL requirements. It is

recommended that a flexible conduit be used to supply power to the junction box and chiller if

used. Check the electric current available. Type and voltage must be the same as listed on the

product data plate.

As you put the bottle filler panel assembly in place on the frame assembly, feed the long green

ground wire and the terminals in the power supply cord through the bushings in the frame

assemlby.

Attach the long green ground wire to the frame assemlby junction box ground, then plug in the

bottle filler power cord.