Aqua Creek Ambassador F-PPXRD-NA-02 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Подъемные системы Aqua Creek Ambassador F-PPXRD-NA-02. Aqua Creek Ambassador F-PPXRD-NA-02 18 страниц. Pool lift

Печатать страницу

Anchor Installation: Core-Drill Retro-Fit

NOTE: 2500PSI MINIMUM STRENGTH 6" THICK OR MORE CONCRETE IS REQUIRED

You will need:

• Core drill and 1½" core drill bit

• Tape measure

• Marking pen

• Hammer

• Cold chisel

• Torpedo level

• 2-part construction epoxy*

• Masking tape

• Black electrical tape (optional)

• Anti-seize packet

*Aqua Creek recommends either

Hilti™ Brand HIT RE-500-SD or

Simpson™ brand SET-XP or equivalent

Mark the 3 hole locations on your deck using the larger holes of the anchor jig plate as

a template. For ADA compliance, confirm the center of the jig plate holes are 22.5 to 38

inches from the pool's edge.

SEE FIGURE 1 ON PAGE 3

Drill the 3 hole locations to 4 1/2 inches deep using the 1 1/2 inch drill bit. Clear all debris

and ensure holes are completely dry.

NOTE: Create a depth marker on the drill bit with black electrical tape to make sure you drill to the right depth.

NOTE: Local bonding regulations may require you to drill one hole larger than the others in order to bond at least

one of the anchor inserts. You may need to saw cut a portion of your deck.

See "Saw Cutting Retro-Fit Instructions" on page 6.

Remove the nuts and the black protective coverings from the threaded anchor inserts.

Thread the 1/2 inch hex bolts and flat washers through the smaller anchor jig plate holes

and into the anchor inserts. Be sure to use anti-seize on the threads! Confirm the tops of

the inserts are flush with the bottom of the plate.

NOTE: We recommend using masking tape around the holes on the bottom of the anchor jig plate to help prevent the

anchor plate from being accidentally epoxied to the pool deck.

Anchor jig plate with hardware

SEE FIGURE 2 ON PAGE 5

Revised 6/28/18