Aqua Creek F-03EZPL Инструкции по установке, монтажу и эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Инструкции по установке, монтажу и эксплуатации для Подъемные системы Aqua Creek F-03EZPL. Aqua Creek F-03EZPL 12 страниц. Ez pool lift

Печатать страницу

SAFETY AND MAINTENANCE INSTRUCTIONS

●Do not play on or around this lift

●Check the EZ Pool LIFT before each use to assure there are no worn parts and that all hardware is

properly tightened. If there are any worn parts, replace them BEFORE using the EZ Pool Lift. You can

call our customer service at 1-888-687-3552 to order any parts.

●Aqua Creek Products, LLC lifts shall be grounded per local codes.

●At least ONCE A WEEK, the EZ Pool Lift must be cleaned with fresh water.

●Wipe all surfaces clean with a damp, non-abrasive cloth. When cleaning the EZ Pool Lift, use non-

abrasive soap and water. Avoid harsh chemicals and disinfectants.

●Always read the label instructions on any cleaner carefully before applying it to a surface.

●The WARNING & INTENDED USE labels on the EZ Pool Lift need to be maintained in readable

fashion. If they become unreadable or faded, please replace the label immediately. Replacement labels

are available from AQUA CREEK PRODUCTS LLC. 1-888-687-3552.

CARE OF YOUR LIFT

Routine cleaning is an absolute necessity to ensure the integrity of the lift. Note that the Aqua Creek Pool Lift should

not be stored in a pump room or in a storage room where pool chemicals are kept. Storing the lift near pool chemicals

may cause rusting and other damage to occur. Your Aqua Creek stainless steel lift is powder coated to protect the

stainless steel from rusting. Most rusting will occur at weld points, crevices, under gaskets, rivets or bolt heads.

The choice of a proper cleaning product is up to the consumer and there are many to choose from. Depending on the

type of cleaning and the degree of contamination (rusting), some products are better than others. For routine cleaning

the products most recommended are gentle soaps or detergents or dilute mixtures of ammonia. For stubborn spots and

stains try using soft scrub with some brisk rubbing.

DO NOT USE POOL WATER TO CLEAN USE ONLY FRESH WATER

If the lift is used DAILY make sure to wash the lift at the end of the day. Wash the lift off using a mild soap and a soft

cloth. Make sure to pay special attention to weld points and crevices. Do not use a bristled brush or steel wool to clean

the lift. Check that the lift is working properly and then place the battery on the charger. It is recommended that the

battery be charged after every day of use.

If the lift is used WEEKLY follow the same steps as above. Also be sure to check all of the contact points (terminals)

for damage or corrosion. If you notice corrosion gently clean the terminals. To clean corrosion from the terminals use a

q-tip and some rubbing alcohol. If the corrosion is particularly stubborn try using a 3M scotch brite pad, but be careful

not to damage the terminals. Apply dielectric grease to the terminals after cleaning them. This will help to prevent

further corrosion. Do not leave the battery on the lift. Always store the battery on the charger whenever the lift is not

being used.

If the lift is used MONTHLY follow the same steps as above. Also check the nuts and bolts to make sure they are

securely fastened (this is always a good idea, no matter how often or infrequently the lift is used). Also make sure to

store the battery on the charger and not on the lift. Leaving the battery on the lift for extended periods will significantly

shorten the battery's lifespan.

If the lift is being STORED for an extended period of time follow all of the steps above. Check for rusting at all

crevice and weld points. If you notice rusting, apply some mild dish detergent to the affected area and take a 3M scotch

brite pad and rub briskly. Afterwards, be sure to rinse the lift with clean water NOT pool water. When storing the lift

make sure it is in a dry area and covered. DO NOT STORE in or around pool chemicals. Be sure to store the hydraulic

ram in an upright, vertical position to prevent leaking fluid.

EZINST-6/27/14

Page 10 of 12