Aqua Creek Products F-MTY600-T Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Помощь в передвижении Aqua Creek Products F-MTY600-T. Aqua Creek Products F-MTY600-T 14 страниц. Pool lift
Печатать страницу
TOOLS REQUIRED:
1/2" WRENCH (2)
1.
Lift the Mighty 600 MAIN ASSEMBLY from the shipping container. Insert the 1.9" [48mm] post
of the MAIN ASSEMBLY into the deck anchor (FIGURE A, PAGE 6). Ease the MAIN ASSEMBLY down
until it rests on the deck surface. Rotate the base until the fi xing anchor hole lines up with the
fi xing anchor. Install the 1/2" x 1 1/2" hex bolt and washer to hold down the lift. Tighten the bolt.
2.
Remove all of the shipping materials from the lift. Slide the CHAIR AND CHAIR ARM ASSEMBLY
up through the top casing of the MAIN ASSEMBLY and connect using the supplied 5/16" hex bolts,
washers and nylock nuts. For standard pool confi guration the CHAIR ARM will be connected
at the top two holes. However, the chair arm can be adjusted up to 6 inches higher, in 2 inch
increments, if there is a need for it. NEVER USE THE LIFT WITHOUT BOTH HEX BOLTS INSTALLED!
5/16" X 3"
HEX BOLT (2)
MIGHTY 600 LIFT
MAIN ASSEMBLY
8
Copyright © 2019 Aqua Creek Products All Rights Reserved
Mighty 600 Assembly Instructions
WARNING:
NEVER LIFT THE MAIN ASSEMBLY
USING THE LINEAR ACTUATOR AS A HANDLE! USE
AT LEAST TWO PEOPLE TO LIFT.
5/16" NYLOCK NUT (2)
5/16" FLAT WASHER (4)
MIGHTY 600 CHAIR
AND CHAIR ARM
FOOTREST ASSEMBLY
Revised 4/23/19