A.J.Antunes 9210825 Руководство - Страница 7
Просмотреть онлайн или скачать pdf Руководство для Тостер A.J.Antunes 9210825. A.J.Antunes 9210825 20 страниц. Club toaster
Печатать страницуOperating Instructions
Follow these steps to start the Club Toaster:
1. Turn on the Power Switch located at the back of
the unit. There will be a 20-second countdown as
the unit sets defaults.
2. The unit will start to warm up and will show the
Wait
message in the display (Figure 3).
NOTE: The Control Panel and display are located
on the back of the unit.
3. When the unit reaches operating temperature, the
display will read Ready (Figure 4).
4. The unit is ready for operation.
NOTE: If the toasting quality needs to be adjusted,
refer to the section titled "Adjusting Toasting
Quality" in the Operation section of this manual.
PLTN
Wait
PLTN
MOTOR
ADJUST
PRGM
CT
BELTS
STOP/START
Figure 3. Club Toaster Wait Display
PLTN
Ready
PLTN
MOTOR
ADJUST
PRGM
CT
BELTS
STOP/START
Figure 4. Club Toaster Ready Display
P/N 1010993 Rev. H 03/15
McDonald's
OPERATION
PREV
NEXT
SELECT
PREV
NEXT
SELECT
CLUB TOASTER CTX-200L
Toasting Clubs
Follow these steps to toast clubs with the Club Toaster:
1. Make sure the unit is turned on and that the
Ready
display reads
2. Insert the club into Bun Feeder (Figure 5).
3. The club will emerge from the toaster into the Bun
Buffer.
Figure 5. CTX-200L Toasting Route
NOTE: For all CTX-200 units, the product pass-
through time is 22 seconds (+/- 2 seconds).
Adjusting Toasting Quality
Follow these steps to adjust toasting quality.
1. At the back Control Panel, press and release the
ADJUST button (Figure 6).
2. Use the PREV and NEXT buttons to adjust the
toasting quality to lighter or darker respectively
(Figure 6).
NOTE: Pressing the PREV button decreases toast-
ing darkness. Pressing the NEXT button increases
toasting darkness.
3. Test several clubs to verify that the product is
toasting at the desired quality.
4. If the toasting quality needs further adjustment,
repeat Steps 1 through 3 as necessary.
NOTE: This setting is maintained when the unit is
powered off. The adjustment range is +/- 10% of
cycle time. Therefore, each adjustment represents a
1% change toward the desired result. Two bars on
the display indicate the adjustment is in the center
position.
7
.
Large Black Arrows
Club Inside
Indicate Club
Bun Feeder
Route Through
toaster
Bun Buffer