Avnet FMC-MULTI-CAM4 Начало работы - Страница 5

Просмотреть онлайн или скачать pdf Начало работы для Блок управления Avnet FMC-MULTI-CAM4. Avnet FMC-MULTI-CAM4 9 страниц.

Extracting the design files

In this section, the archive containing the pre-built examples will be extracted to your computer.

1. Download the following archive:



Getting Started Design

2. Extract the archive to your computer

a. For Linux, use the unzip utlity.

b. For Win dows, use the 7zip utility

If you need 7zip, get it here

Running the Getting Started design

Setup the ZCU102 or ZCU104 hardware as follows:

1. Connect the FMC-MULTICAM4 FMC module to the FMC connector (J5 for HPC0 FMC on ZCU102,

J5 for LPC FMC on ZCU104)

2. Attach the four AR0231AT camera modules to their respective MAX96705 Serializer modules,

and connect to the FMC-MULTICAM4 FMC module with the cable assembly

3. Connect the power supply to the 12V connector (J52 on ZCU102, J52 on ZCU104)

4. Connect the HDMI display with an HDMI cable to the top connector of dual HDMI connector (P7

on ZCU102, P7 on ZCU104)

5. Connect a micro-USB cable to the USB-UART connector (J83 on ZCU102, J164 on ZCU104)

Use the following settings for your terminal emulator:



Baud Rate: 115200



Data: 8 bit



Parity: None



Stop: 1 bit



Flow Control: None

6. Insert SD card (FAT formatted) with pre-built image copied from one of the following

directories:



ZCU102 : sd_card/zcu102_rv_mc4_filter2d_optflow



ZCU104 : sd_card/zcu104_rv_mc4_filter2d_optflow

7. Set boot mode to SD card



ZCU102 : SW6[4:1]: off,off,off, on



ZCU104 : SW6[4:1]: off,off,off, on

8. Turn on the power switch (SW1 on ZCU102, SW1 on ZCU104)

Page 5

FMC_MULTICAM4_Getting_Started_2018_2_02.zip

https://avnet.egnyte.com/dl/Qrt2cF9umB

7zip